181i Fabricator User Manual

Fabricator 181i
INSTALLATION, OPERATION AND SETUP 3-14 Manual 0-5191
3.12 Torch Adapter Thumb Screw Replacement
1. Place unit on its back.
Art # A-11482_AB
2. Remove 2 screws in bottom of the front panel. A securing block will become detached and fall free from
the front panel as you turn each screw out. Set these aside for reassembly. Leave screws sitting in the
pockets of the panel.
Screws
Securing Block
Art # A-11483
3. Open the wire compartment door and release the tension knob so the pressure arm and tension knob hang
downwardly.
Art # A-11484
Pressure Arm
Tension Knob