Manual

Installation Instructions 5/22/00

11. Reinstall any covers removed (see WARNING).

12. Install the proper torch consumables for the Power Supply amperage.

13. Reconnect main input power to the Power Supply and turn the unit ON.

14. Set air pressure to 60 - 70 psi (4.1 - 4.8 bar).

15. Test torch for proper operation.

NOTE

Every effort has been made to provide complete and accurate information in this manual. However, the publisher does not

assume and hereby disclaims any liability to any party for any loss or damage caused by errors or omissions in this manual,

whether such errors result from negligence, accident or any other cause.

WARNING

Make sure that the Control Connector Plug

wires DO NOT contact the Adapter Fitting after

all leads are connected.