With TotallyHandsFreeTM Voice Commands Product Information Guide
INDEX OF KEY FEATURES Charging Pairing your device Commands TRADEMARK ACKNOWLEDGEMENT P. 5 P. 6, 10 P. 9 > Pair Mode P. 10 > Am I Connected? P. 11 > Phone Command P. 12, 23 > Check Battery P. 13 > Redial P. 14 > Call Back P. 14 > What Can I Say? P. 14 > Cancel Tweebaa and TweeBot are registered trademarks of Tweebaa Inc. iPhone and Siri is registered trademark of Apple Inc. Samsung S Voice is a trademark of Samsung Group. Facebook is a registered trademark of Facebook, Inc.
accepted and will be returned to you at your expense. All authorized returned products must be accompanied by proof of purchase and a brief explanation of the problem. For out - of - warranty repairs and service, please contact our Customer Service Department for instructions. The repair shall be warranted for 90 days. IMPORTANT: YOUR RECEIPT IS PART OF YOUR WARRANTY AND MUST BE RETAINED AND PRODUCED IN THE EVENT OF A WARRANTY CLAIM. SERVICE Service in United States and Canada, contact: Tweebaa Inc.
ABOUT TWEEBOT ® TweeBot is the world 1st completely hands-free Bluetooth Speaker. TweeBot has amazing sound quality. PLUS - it uses voice activation technology to allow you to give verbal commands to operate any Bluetooth enabled device (i.e. Smartphone, Tablet) without touching any button. To get the full capability of TweeBot , it is IMPORTANT to read these instructions. TweeBot could do much more than a Bluetooth Speaker.
Industry Canada This device IC is 20536-TWEEBOT RSS (category 1 equipment) This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to the following two conditions: 1.This device may not cause interference. 2.This device must accept any interference that may cause undesired operation of the device.
CHARGING COMPLIANCE TweeBot has a built-in Li-ion battery (3.7V, 1.6A), so it can be used without connecting to a power supply. To charge the battery, follow these steps: FCC ID: 2AFRQ-TWEEBOT 1. Connect the micro USB connector to the TweeBot DC 5V input. 2. Plug the USB full-size connector into the 12V accessory car plug provided. (A common USB type AC charger (DC 5V, 500mA) can be used as well.) 3. TweeBot can also be charged by plugging the USB connector into a computer.
Problem Recommended Solutions I cannot hear Siri or S Voice loud enough when I get a response to my request When you have access to your mobile device's voice control, adjust the volume control up on TweeBot and also on your mobile device. I have TweeBot paired to my smartphone and I want to let a friend pair. How can I get his/her phone to connect? Say “Hello Tweebaa” and give the command “Pair Mode”. TweeBot will respond with “Your phone is connected.
b. Alternatively, you can press the Bluetooth icon button (hold for few seconds) until the status light is blinking blue/red. This goes directly into pair mode. Check you phone and search for the Bluetooth device named “TweeBot ” and select it.
SPECIFICATIONS ANDROID Frequency Range: 2.402 GHz - 2.480 Ghz Channels: 79 Carrier Power: <2.5 mW Modulation: GFSK Frequency Stability: +-75 Khz Tweebot Standby Time: 336 Hours Charging Time: 5 Hours Power Supply: 5V, 500mA Ambient Temperature: 0℃ ~ 45℃ Humidity: 0%~90% Size(mm): 209*85 Bluetooth Range: 30 feet If you are using an older phone with Bluetooth , it might be necessary to enter a password during pairing. The code to use is 0000 (4 zeros).
TWEEBOT TotallyHandsFree TM OPERATION Voice commands are initiated with the words: “Hello Tweebaa.” Anytime you say those words, TweeBot will respond with: “Say a command.” TweetBot recognizes eight commands that are easy to master in just a few uses. However, it isn’t even necessary to refer to this manual as you can always ask TweeBot “What Can I Say?” to get a verbal list of the available commands. It’s that easy! Try these additional commands once you are connected to Siri : Solve math problems.
Do Not Disturb After Siri ’s two-beep signal… TM TweeBot TotallyHandsFree operation is always active whenever the power switch is in the ON position. Battery life is reduced as a result. Turn the power switch OFF when not using TweeBot for an extended period. You: “Turn on do not disturb” Same procedure for turning off “do not disturb”, and the command is “turn off do not disturb”.
If you are paired to a device but would like to pair to a different device: You: “Hello Tweebaa.” TweeBot: “Say a command.” You: “Pair Mode.” TweeBot: “Your phone is connected. Do you still want to enter Pair Mode? ” You can respond with “Yes” or “No” You: “No” TweeBot: “Pair Mode cancelled.” OR You: “Yes” TweeBot: “Pair Mode. There is no active phone connected.” Pair to the new device and once paired, TweeBot will say: “Your phone is connected.
Change title to “Shopping List” (or whatever you want to call it). Tap “Done” (top right corner). If you ARE NOT connectedTweeBot: “Attempting to connect - after a brief delay - no phone found.” If connected, TweeBot:“Your phone is connected. You have bars network signal strength.” The signal strength reported is the strength of your mobile carrier connection.
TweeBot will beep twice. Wait a second or two to hear the Siri beeps...then, give your voice command to Siri as you normally would. TweeBot will read aloud the last 25 calls in your phone’s history including name, phone number and time. Add an item to Reminders ExampleYou: “How far is it to the nearest coffee shop?” Siri : “Starbucks is less than a mile away. Would you like to get directions?” You: “No.” Siri : “Okay.” After several seconds, Siri will transfer voice command back to TweeBot .
Read Email Summary Command #5: REDIAL TweeBot can read a list of your emails to you. After Siri ’s twobeep signal… You: “Hello Tweebaa.” TweeBot: “Say a command.” You: “Redial.” TweeBot: “Redialing last outgoing call.” You: “Read Email” TweeBot: If there are more than 4 emails, TweeBot will say “Would you like to read all emails?”. Say “Yes” to continue reading or “No” to end this function.
Command #8: CANCEL Anytime you say “Hello Tweebaa” you can respond to “Say a command” with “Cancel.
WHAT ELSE CAN TWEEBOT DO? Exploring the “Phone Command” (iOS Devices) Take some time to explore the amazing things your phone can do for you, now made totally hands-free with TweeBot ! Here are various commands to try with iOS devices. (Android devices have similar commands.
> “Hey Siri ” function (only available with iOS 8 and higher devices) The “Hey Siri ” function allows iOS users to speak with Siri without pressing the phone’s home button, and to speak through TweeBot without needing the “Hello Tweebaa” and “Phone command” steps. > Adjusting Volume To adjust TweeBot ’s volume, rotate the smartControl clockwise to increase the volume or counter-clockwise to decrease it. In order to use “Hey Siri ” with Tweebot , make sure the feature is activated on your phone.
> Stereo Audio Output To Home System Connecting TweeBot to a home audio system will provide a useful way to hold your Bluetooth connected smartphone or tablet in your hand and let TweeBot act as an interface to your sound system. Though each audio system is a little different, TweeBot ’s 3.5 mm stereo output can be connected using a variety of cables and connectors available on-line or at retail stores.
> Disable Manual Controls Especially during sporting activities like biking & golfing, shock may cause the controls on the smartControl to play or pause unintentionally. To avoid this situation, the manual controls can be temporarily disabled by pressing and holding the button on the top of TweeBot . Hold it for a few seconds until an audible confirming signal is heard. To resume normal operation, press and hold again.
