Owner's Manual

ASSEMBLY INSTRUCTIONS – ELECTRIC HEATER

NOTE:

a) The heater must be permanently installed and hard wired by a licensed contractor.

b) Twin Eagles electric heater is shipped with the heating element uninstalled to prevent it from

breaking from any possible shipping impact.

c) Assembly procedure must be performed with no electrical power to the unit.

1) When you open the box, all components should be organized as seen on the picture. Remove the box

with the element and place it in a safe area, you will it need later on. Remove the rest of the cardboard

inserts including the mounting brackets on each side. Then take the heater out of the box and place it on a

flat surface.

2) Look at the rear area of the heater unit and reference the UL label for the electrical requirements. The

electrical requirements should either be;

i. 120V (1500W) (TEEH-1512)

ii. 240V (2500W) (TEEH-2524)

iii. 240V (3500W) (TEEH-3524)

A) Once electrical requirements on the heater have been identified, compare it versus the elements

electrical rating they’re to be the same. If the two electrical requirements are not the same, contact

the customer service department. If they are the same, continue by removing the end-plates on each

side.

B) Open the hold-down-clip on both sides and CAREFULLY install the heating element

(no polarity) and

remove the outer nut

(

”) and insert the round wire terminal into the element end. Place the outer

nut back in and tighten the outer nut while holding the inner nut with a second wrench. Be careful not

to damage the element’s ceramic ends during this process. If connection is left loose it could cause

element to fail. Then bring down the hold-down-clips on both sides. With the use of a cloth, wipe

the element and reflector to eliminate any finger prints or debris.

C) Install the front grill safety cover by pushing the legs into the seam as seen on picture “C”.

D) Screw the end plates back on and remove the protective blue plastic.

Mounting

brackets

Element

enclosed

Electrical

junction box

”

Inside &

outside

nut

End Plates

Hold-Down-Clip

UL Label

Front Grill Safety Cover

Heating

Element

Ceramic