Twin Eagles Outdoor Refrigerator Model: TEOR24-F 18910B 08/18
CONTENTS Contents: Important Safety Instructions Safety information ...............................................................2 Unpacking your appliance ..................................................3 Warranty registration .....................................................3 Installing your appliance ......................................................4 Cabinet clearances .........................................................4 Leveling the appliance ........................................
UNPACKING YOUR APPLIANCE ! Warranty Registration WARNING It is important you send in your warranty registration card immediately after taking delivery of your appliance or you can register online at: http://www.twineaglesgrills.com/contactus.shtml EXCESSIVE WEIGHT HAZARD Use two or more people to move product. Failure to do so can result in personal injury. The following information will be required when registering your appliance.
INSTALLING YOUR APPLIANCE Select Location The proper location will ensure peak performance of your appliance. We recommend a location where the unit will be out of direct sunlight and away from heat sources. To ensure your product performs to specifications, the recommended installation location temperature range is from 55 to 115°F (13 to 46°C). Front Grille, keep this area open. Cabinet Clearance Ventilation is required from the bottom front of the appliance.
INSTALLING YOUR APPLIANCE ! WARNING Electrical Shock Hazard Do not remove ground prong • Do not use an extension cord with this appliance. They can be hazardous and can degrade product performance. • This appliance should not, under any circumstances, be installed to an un-grounded electrical supply. • Do not remove the grounding prong from the power cord. (See Figure 3). • Do not use an adapter. (See Figure 4). • Do not splash or spray water from a hose on the appliance.
INSTALLING THE ANTI TIP DEVICE FOR FREESTANDING INSTALLATIONS Anti-Tip Bracket WARNING ! • ALL APPLIANCES CAN TIP RESULTING IN INJURY. • INSTALL THE ANTI-TIP BRACKET PACKED WITH THE APPLIANCE. • FOLLOW THE INSTRUCTIONS BELOW 211⁄2" (54.6 cm) Leveling Leg Bottom View of Refrigerator Front of cabinet Figure 7 Anti-Tip Device ! Step by step instructions for locating the position of the bracket: WARNING 1) Decide where you want to place the refrigerator.
INSTALLING THE ANTI TIP DEVICE FOR FREESTANDING INSTALLATIONS NOTE When the floor mounted anti-tip bracket is used the minimum adjusted height of the cabinet is increased by 3 ⁄8" (9 mm). nt o Fro net bi f ca line Sid eo f c Rear Leveling leg ab ine t li ne Screw 211⁄2" (54.
PRODUCT DIMENSIONS ROUGH-IN OPENING DIMENSIONS MODEL "A" "B" TEOR24-F 24" (61 cm) **34" to 35" (86.4 to 88.9 cm) CABINET DIMENSIONS "C" "D" "E" "F" "G" "H" "J" * 237⁄8" (60.7 cm) 333⁄4" to 343⁄4" (85.7 to 88.3 cm) 2323⁄32" (60.2 cm) 265⁄16" (66.8 cm) 4613⁄32" (117.9 cm) 265⁄16" (66.
PRODUCT DIMENSIONS PRODUCT DATA MODEL ELECTRICAL REQUIREMENTS # PRODUCT WEIGHT TEOR24-F 115V/60Hz/15A 140 lbs (63.6 kg) "J" "H" "G" "D" "E" Figure 11 211⁄2" (54.6 cm) "F" * Depth dimension of rough-in opening may vary depending on each individual installation. To recess entire door "F" dimension plus 1" (2.5 cm) for thickness of power cord plug is required. ** Minimum rough-in opening required is to be larger than the adjusted height of the cabinet.
USING YOUR ELECTRONIC CONTROL Alarm Figure 12 close-up of control Set F Colder Press and Hold Warmer ON/OFF Press and Hold Starting your refrigerator Plug the refrigerator power cord into a wall outlet. Your refrigerator will begin cooling after power is applied. If your refrigerator does not start, check that the refrigerator is turned on and the set temperature is cold enough.
SHELVING CONFIGURATIONS Loading Tips and Suggestions Your appliance is equipped with a cantilever shelf system which provides maximum adjust ability and customizing of the shelving arrangements listed below. 24" (61 cm) Wide Models: With a solid door and door racks. Figure 14. Figure 14 (2) perforated slide out shelf (See Figure 15).. (1) full width door storage rack. (1) half width door storage rack.
SHELVING CONFIGURATIONS ! To Add or Remove a Shelf CAUTION Never try to move a loaded shelf, remove everything from the shelf before moving. Use both hands when moving the shelf. Installed shelf tang Remove stored product from the shelf. Do not try to remove a loaded shelf from the appliance. Grasp the shelf front with both hands, rotate the front upward and lift out. (See Figure 16).
CARE AND CLEANING Front Grille Be sure that nothing obstructs the required air flow openings in front of the cabinet. At least once or twice a year, brush or vacuum lint and dirt from the front grille area (see page 4). ! ! WARNING Electrocution Hazard • Never attempt to repair or perform maintenance on the appliance until the main electrical power has been disconnected. Turning the appliance control "OFF" does not remove electrical power from the unit's wiring.
CARE AND CLEANING Outdoor Product Long-Term Storage / Winterization: 18. Do not place a cover on the unit, as this can trap condensation. 1. Time to Winterize, when the daily low ambient temperature is at or below 38°F (3.3°C). ! CAUTION After completion of the above, you may choose to store the unit indoors, although this is not required. Operation of the unit at ambient temperatures below the recommended Winterization temperature will void your warranty. 2. Turn unit off, (see page 10) 3.
STAINLESS STEEL MAINTENANCE AND ENERGY SAVING TIPS Background NOTE Stainless steel does not stain, corrode, or rust as easily as ordinary steel, but it is not stain or corrosion proof. Stainless steels can discolor or corrode if not maintained properly. Stainless steel products should never be installed, or stored in close proximity to chlorine chemicals. Stainless steels differ from ordinary carbon steels by the amount of chromium present.
OBTAINING SERVICE How to Obtain Service If trouble occurs during normal operation, first check the troubleshooting guide on page 17 to see if any of these simple steps may correct the problem. If service becomes necessary: 1. If the product is within the first year warranty period, please call Twin Eagles Customer Service at (562) 8023488 for directions on how to obtain warranty coverage in your area. 2.
TROUBLESHOOTING If You Do Need Service If you do need service, contact your dealer or Twin Eagles. In any correspondence, refer to the service number and serial number of your ice machine which is located on the upper left hand side of the wall liner. Retain your proof of purchase. You may want to record these numbers in Table A below.
WARRANTY Entire Product Limited One Year Parts and Labor Warranty Twin Eagles warrants that it will supply all necessary parts and labor to repair or replace in the end user’s home or office, any component which proves to be defective in material or workmanship, subject to the condition and exclusions stated below, for a period of one year from the date of purchase by the end user.
13259 http://www.twineaglesgrills.com/contactus.
41014793 rev C 7/26/18 13259 20
