User guide

P/N 18634A 04/11

TWIN EAGLES

EPPANYAKI GRIDDLE

GAS CONVERSION KIT FROM LP TO NG

PN: CKNG-TETG

FOR MODELS: TETG

WARNING: BEFORE WORKING ON THIS APPLIANCE DISCONNECT

GAS AND ELECTRICAL SUPPLIES.

WARNING: INSTALLATION/GAS CONVERSION MUST BE PERFORMED

BY A QUALIFIED TECHNICIAN.

FOR YOUR RECORDS

IMPORTANT: Retain original proof of purchase to establish warranty period.

Please record the following information and refer to this information when

contacting the company or an authorized service agent. This information is

found on the rating/data plate located on the inside wall of the left side Panel.

Serial No. of Teppanyaki Griddle:

_____________________________________________________________

Date of Natural Gas Conversion:

_____________________________________________________________

Natural Gas Conversion by:

_____________________________________________________________

PAGE 1
WARNING: BEFORE WORKING ON THIS APPLIANCE DISCONNECT ! GAS AND ELECTRICAL SUPPLIES. TWIN EAGLES TEPPANYAKI GRIDDLE GAS CONVERSION KIT FROM LP TO NG PN: CKNG-TETG FOR MODELS: TETG ! WARNING: INSTALLATION/GAS CONVERSION MUST BE PERFORMED BY A QUALIFIED TECHNICIAN. FOR YOUR RECORDS IMPORTANT: Retain original proof of purchase to establish warranty period. Please record the following information and refer to this information when contacting the company or an authorized service agent.
PAGE 2
1. Check to make sure that you have the NG Gas Conversion Kit as follows: 2. 2-5) Replace the orifices #55, used for LP, and replace it with orifice #45, used for PN 15303, Regulator, Natural Gas (1 pc) NG. Use a 1/2" Deep Socket and a Socket Wrench to remove and replace the orifice. b. PN 15110-45, Orifice #45 (2 pcs) Replace Griddle Plate Assembly when finished and re-install the Thermostat Bulb. c. PN: 18351, Label, Conversion, Gas (1 pc) a.
PAGE 3
. Testing 3-1) Check for leaks. 3-2) NEVER USE THE APPLIANCE WITHOUT FIRST LEAK TESTING THE GAS CONNECTION. a) Prepare a leak testing solution of sudsy water by mixing in a spray bottle with half liquid soap and half water. b) Confirm that all control knobs are in the “OFF” position. c) Turn the main gas valve supply “ON”. d) Apply leak testing solution by spraying on the pipe joints, fittings, and hose. e) A gas leak is detected if; i. there is a faint gas smell ii.