User Manual

P/N:18633A 04/11

TWIN EAGLES

EPPANYAKI GRIDDLE

GAS CONVERSION KIT FROM NG TO LP

PN: CKLP-TETG

FOR MODELS: TETG

WARNING: BEFORE WORK ING ON THIS APPLIANCE DISCONNECT

GAS AND ELECTRICAL SUPPLIES.

WARNING: INSTALLATION/GAS CONVERSION MUST BE PERFORMED

BY A QUALIFIED TECHNICIAN.

FOR YOUR RECORDS

IMPORTANT: Retain original proof of purchase to establish warranty period.

Please record the following information and refer to this information when

contacting the company or an authorized service agent. This information is

found on the rating/data plate located on the insid e wall of the left side Panel.

Serial No. of Teppanyaki Griddle

________________________________________________________

Date of LP Gas Conversion:

________________________________________________________

LP Gas Conversion by:

________________________________________________________

PAGE 1
WARNING: BEFORE WORKING ON THIS APPLIANCE DISCONNECT ! GAS AND ELECTRICAL SUPPLIES. TWIN EAGLES TEPPANYAKI GRIDDLE GAS CONVERSION KIT FROM NG TO LP PN: CKLP-TETG FOR MODELS: TETG ! WARNING: INSTALLATION/GAS CONVERSION MUST BE PERFORMED BY A QUALIFIED TECHNICIAN. FOR YOUR RECORDS IMPORTANT: Retain original proof of purchase to establish warranty period. Please record the following information and refer to this information when contacting the company or an authorized service agent.
PAGE 2
1. Check to make sure that you have the LP Gas Conversion Kit as follows: 2-5) Replace the orifices #45, used for NG, and replace it with orifice #55, used for LP. a. PN: 12602, Coupling, 3/8 x ½ FIP (1 pc) Use a 1/2" Deep Socket and a Socket Wrench to remove and replace the orifice. b. PN 15302, LP Regulator with Hose (1 pc) Replace Griddle Plate Assembly when finished and re-install the two Thermostat Bulbs. c. PN:15110-55, Orifice #55 (2 pcs) d. PN: 18351, Label, Conversion, Gas (1 pc) 2.
PAGE 3
Warning: The LP Hose and Regulator Assembly should be a Type 1 Connection and set at 11” of Water Column. LP Hose with regulator 3. Testing 3-1) Make sure the regulator has been properly connected, replaced for LP Gas 3-2) Check for leaks. 3-3) NEVER USE THE UNIT WITHOUT FIRST LEAK TESTING THE GAS CONNECTION. a) Prepare a leak testing solution of sudsy water by mixing in a spray bottle with half liquid soap and half water. b) Confirm that all control knobs are in the “OFF” position.