User's Manual
9
WARNING: Make sure the power is turned off before proceeding. Any electrical repairs
or rewiring of this unit should be carried out by a licensed electrician in accordance with
national and local codes.
WARNING: Do not use this heater if any part of it has been under water. Immediately
electrical system.
Warning: During any service of this appliance, the power to the unit must be turned off.
First turn the main power switch to the “OFF” position. Then remove the electrical plug
from the wall outlet.
Warning: Disconnect power before attempting any maintenance or cleaning to reduce the
If repairing or replacing any electrical component or wiring, the original wire routing,
color coding and securing locations must be followed.
WARNING: Electrical outlet wiring must comply with local building codes and other
TROUBLESHOOTING GUIDE
PROBLEM SOLUTION
1. Heater does not blow warm air. 1a. The ambient temperature is higher than the thermostat
setting.
1b. Unplug the unit from the wall outlet for 2 hours. After 2
hours plug the unit back into wall outlet, and operate as
normal.
1c. Check if the air inlet is blocked.
2a. Check if the air inlet is blocked.
3. The heater does not run in the
program.
3a. Check that the thermostat is higher than the room
temperature.
4. The heater is not responding to
signals from the remote control.
4a. The remote and heater body may have become unpaired.
To re-pair the remote and heater press and hold the
HEATER and ENTER buttons simultaneously. The heater
body will emit a long beep to indicate pairing was
successful.
4b. See display to judge if no power of battery.
4c. Remote can be opeate the unit within 7 m. Need to see if
there have a long distance between remote control and
hetaer body
.
5. The heater does not work.
5a. Check the main power switch on the back of heater if it is
in the ON position;
5b.
The indicator light on the power cord not lit. Press the
RESET button, if the indicator becomes re-lit function is
normal.