User Manual

Chapter 04: Upgrading Your Sahara Slate PC 33
adapter is located at the bottom of the slot
and is seated inside a small slot
connector.
4. The wireless card is held in place
by two small screws. First,
carefully remove the yellow
tape covering the screws and
antenna leads. Then remove the
screws and set them aside in a
safe place. Once the screws are
removed, the card will pop up
slightly.
5. Carefully, slide the card out of
the slot. Be sure to unscrew the
antenna leads from the card
before fully removing the card
from the interior of the
compartment.
6. Take the new wireless networking
card you obtained from your
dealer and carefully align it into
the connector slot. Attach the
antenna leads to the card
before inserting it fully into the
compartment.
7. Once the leads are connected,
press downward on the card to push it
into position and replace the screws to hold
the card in place.
8. Replace the tape over the screws and antenna leads and
replace the cover and tighten the screws that hold the cover
in place.