User Manual

j k
l m
n o n o p o q
p
q n
p
l
o q r
s r t k
v y
A B
D
C
E
F G
------ TAIL CONTROL RODS ------
PART II
 Grab the small thread brass fitting
and the clevis as shown
 Thread the brass part in approx as
far as shown. This will give you a
little adjustment in both directions if
needed in the future
 Repeat for the other clevis
 ELECTRONICALLY CENTER THE
TWO TAIL SERVOS
 LOCK THE CONTROL SURFACES IN
THEIR NEUTRAL POSITION
 Grab one of the clevis assemblies just
made...
 ... and attach it to the control surface
horn with one of the little brass pins.
The hole in the horn may need to be
cleaned out a little. Make sure the
brass pin fully engages the clevis,
and snaps into it’s fully seated
position