User Manual

ManualsBrandsTwo Brothers Racing ManualsSensors2008-10 Suzuki LTR450

ITBR001-151-A

2008-10 Suzuki LTR450 - 1

2008-10 Suzuki LTR450

Installation Instructions

PLEASE READ ALL DIRECTIONS BEFORE STARTING INSTALLATION

FOR RACE USE ONLY

DOWNLOAD THE TOPTUNE SOFTWARE

AND LATEST MAPS FROM OUR

WEBSITE:

www.twobros.com

401 S. Grand Ave. Santa Ana, CA 92705

(800) 211-2767 www.twobros.com

PARTS LIST

1Juice Box Pro

1 USB Cable

1 Top Tune CD-ROM

1 Installation Guide

2Velcro

1 Alcohol swab

1 Rev Extension Plug

Summary of content (4 pages)

PAGE 1
2008-10 Suzuki LTR450 Installation Instructions PARTS LIST 1 1 1 1 2 1 1 Juice Box ProTM USB Cable Top Tune CD-ROM Installation Guide Velcro Alcohol swab Rev Extension Plug FOR RACE USE ONLY DOWNLOAD THE TOPTUNE SOFTWARE AND LATEST MAPS FROM OUR WEBSITE: www.twobros.com PLEASE READ ALL DIRECTIONS BEFORE STARTING INSTALLATION 401 S. Grand Ave. Santa Ana, CA 92705 (800) 211-2767 www.twobros.
PAGE 2
Selecting the Map Position The Juice Box Pro comes loaded with up to ten maps. Using a #1 Phillips screwdriver, turn the map select dial to toggle between the loaded maps. Refer to the map position table below for the maps included in your Juice Box Pro. Using the RPM Range Dials The Low, Mid, and High RPM Dials refer to the RPM range, in thirds, of your vehicle. Each dial allows +/- 10% fuel adjustment on top of what fuel changes are done in the map.
PAGE 3
unplug Figure A The ignition must be turned OFF before installation. 1 2 3 4 5 Remove the seat. Remove the plastic shroud around the fuel tank. Lay the Juice Box Pro in the tail section. Route the wiring harness from the Juice Box Pro towards the throttle body. Unplug the stock wiring harness from the injector and the throttle position sensor (TPS) as shown in Figure A. 6 Attach the connectors from the Juice Box Pro to the stock wiring harness and the fuel injector as shown in Figure B.
PAGE 4
9 Using the supplied velcro, secure the Juice Box Pro to the rear fender as shown in Figure D. Position the Juice Box Pro so it does not interfere with the foam pads on the bottom of the seat. Figure D Make sure to clean both surfaces with the alcohol swab before attaching. ITBR001-151-A 10 Locate the white 6-pin diagnostic connector behind the headlight. This connector is covered with a rubber boot. 11 Attach the Rev Extension plug to this connector. 12 Replace the plastic shroud around the fuel tank.