Manual

V.A.L.E.
VARIABLE AXIS LOCKING EXHAUST
TM
Parts List
IMPORTANT - PLEASE READ CAREFULLY
We recommend that this performance part be installed by a qualied
motorcycle technician. If you have any doubts as to your ability to install this
performance part, please consult with your local motorcycle dealer. Read all
instructions rst before starting installation. Make sure the motorcycle and
exhaust system are completely cool before starting the installation. Also,
make sure the bike is secure on a centerstand or ideally a service lift during
installation. Be sure to save all stock components for possible use later.
Installation Instructions
1. Make sure the bike is completely cool before starting the
installation. Make sure the bike is secure on a centerstand
or ideally a service lift.
2. Remove mufer joint springs, set aside to re-use later.
3. Remove mufer mounting bolt and decorative washer, set
aside to re-use washer later.
4. Attach TBR slip tube to TBR mufer using the 2 piece
X-Rings and 6x14mm socket head cap screws with lock
washer that are provided. Leave loose enough to make
some adjustments on the motorcycle.
5. Attach mufer assembly to motorcycle using the OEM
springs and supllied mufer clamp. Use the supplied
8x20mm socket head cap screw and OEM washer to
secure mufer clamp.
*a small amount of high temp silicone on slip joint may
be used.
6. Align mufer and tighten the 4 X-Ring bolts.
7. Double check your work to ensure everything is tight and
properly installed.
8. Before you run the bike, clean off all ngerprints and
dirt, as any oily residue will etch the metal and become
somewhat permanent when the system gets hot. Run
the bike and enjoy. It is normal for some white smoke to
appear the rst time you start the bike. This is packing/
manufacturing oil from inside the pipe burning off.
Check for gaps or leaks. If you nd a leak, a little high
temperature silicon sealant should x it. After 50 to 100
miles, recheck all fasteners for tightness.
2008-09 BMW
F650GS / F800GS
V.A.L.E.™ Slip-On Exhaust System with M-2 Exhaust Canister
Part # 005-2630406V / 005-2630407V / 005-2630408V
Qty. Description Part Number
1 M-2 Mufer Canister Varies
1 Slip-On Tube Assembly 005-26304S
1 Mufer Clamp Varies
1 HARDWARE KIT 005-263-3
1 X-Ring Kit 005-7-2-3KIT
1 8x20 Sockey Head Cap Screw 005-SH820
1 Permatex Ultra Black Gasket Maker 031-P22072
1 TBR Sticker Kit 015-10212