Owner manual

V.A.L.E.

V a r i a b l e a x i s l o c k i n g e x h a u s t

IMPORTANT - PLEASE READ CAREFULLY

Installation Instructions

7. Install supplied TBR mufﬂer hanger bracket using the

OEM bolt and nut.

8. Loosely attach TBR slip-tube to mufﬂer using the supplied

2-piece X-ring with the supplied (4) 6x20mm socket head

cap screws and lock washers.

1. Make sure the bike is completely cool before starting the

installation. Make sure the bikes parking brake is set.

2. Remove OEM heat shield.

3. Remove OEM mufﬂer joint.

4. Remove OEM mufﬂer mounting bolt, this bolt will

be re-used.

5. Remove OEM mufﬂer assembly.

6. Remove OEM mufﬂer joint gasket.

2010 Can-Am

SPYDER RT

V.A.L.E.™ Slip-on Exhaust System with M-5 Canister

Part # 005-2830419V / 005-2830420V

We recommend that this performance part be installed by a qualied

motorcycle technician. If you have any doubts as to your ability to install this

performance part, please consult with your local motorcycle dealer. Read all

instructions rst before starting installation. Make sure the motorcycle and

exhaust system are completely cool before starting the installation. Be sure

to save all stock components for possible use later.

**This product has not been tested with all available accessories and some

items may cause excessive heat. Excessive heat may cause damage to your

vehicle. Two Brothers Racing will not be responsible for damaged parts.

PAGE 1
Installation Instructions 1. Make sure the bike is completely cool before starting the installation. Make sure the bikes parking brake is set. 7. Install supplied TBR muffler hanger bracket using the OEM bolt and nut. 2. Remove OEM heat shield. 2010 Can-Am V.A.L.E. TM V a r i a b l e A x i s L o c k i n g E x h a u s t SPYDER RT V.A.L.E.™ Slip-on Exhaust System with M-5 Canister Part # 005-2830419V / 005-2830420V 3. Remove OEM muffler joint. 4.
PAGE 2
Installation Instructions 9. Loosely Install supplied barrel-clamp on slip-tube end. 10. Install rubber lined muffler clamp over TBR muffler assembly. 14. Install TBR heat shield to slip-tube using the OEM heat shield mounting bolts. V.A.L.E. TM 2010 Can-Am V a r i a b l e A x i s L o c k i n g E x h a u s t SPYDER RT V.A.L.E.™ Slip-on Exhaust System with M-5 Canister Part # 005-2830419V / 005-2830420V 11.