Instruction Manual

20. Attach mufer clamp assembly under the heat shield using
the 2 OEM bolts and 6mm nuts.
21. Remove upper & lower half of mufer clamp assembly and
carefully slide mufer assembly into place making sure that
exhaust tube & barrel clamp slip over collector.
22. Slip upper & lower halves of mufer clamp onto mufer
canister and attach to “L” brackets using supplied 8mm nuts
and 8mm bolts.
23. Making sure that the mufer canister is aligned correctly,
securely tighten the 8mm bolts connecting the mufer
clamp halves to the “L” brackets
Installation Instructions Continued
12. Remove right side driver’s footpeg bolts and carefully
remove the exhaust tube heat shield.
13. Loosen the OEM barrel clamp connecting the exhaust tube
and header.
14. Carefully remove mufer and exhaust tube with heatshield.
15. Remove metal OEM exhaust gasket.
16. Assemble the V.A.L.E.™ unit by slipping the S-bend tube
through the X-Lite™ ring. Use the 4 (four) 6 x 14mm bolts
and split lock washers to loosely attach the X-Lite ™ ring to
mufer inlet.
17. Attach the X-Lite™ V.A.L.E.™ assembly to the mufer canister
using the 4 (four) 6mm x 14mm socket head cap screws. Leave
loose for now.
18. Apply a bead of high-temp sealant to the inside of the lower end
of the exhaust tube.
19. Assemble the 2 (two) halves of the mufer clamp and “L” brackets
as shown below using the supplied 8mm ange nuts and 8mm
socket head cap screws.
Mufer Inlet
X-Lite™ Ring
S-Bend Tube
V.A.L.E.™ Assembly Detail
Continued on Page 3