Owner's manual

ManualsBrandsTwo Brothers Racing ManualsCarYamaha FJR1300

ITBR001-156

2006-09 Yamaha FJR1300 - 1

2006-09 Yamaha FJR1300

Installation Instructions

PLEASE READ ALL DIRECTIONS BEFORE STARTING INSTALLATION

FOR RACE USE ONLY

DOWNLOAD THE TOPTUNE SOFTWARE

AND LATEST MAPS FROM OUR

WEBSITE:

www.twobros.com

401 S. Grand Ave. Santa Ana, CA 92705

(800) 211-2767 www.twobros.com

PARTS LIST

1Juice Box Pro

1 USB Cable

1 Top Tune CD-ROM

1 Installation Guide

2Velcro

1 Alcohol swab

Summary of content (4 pages)

PAGE 1
2006-09 Yamaha FJR1300 Installation Instructions PARTS LIST 1 1 1 1 2 1 Juice Box ProTM USB Cable Top Tune CD-ROM Installation Guide Velcro Alcohol swab FOR RACE USE ONLY DOWNLOAD THE TOPTUNE SOFTWARE AND LATEST MAPS FROM OUR WEBSITE: www.twobros.com PLEASE READ ALL DIRECTIONS BEFORE STARTING INSTALLATION 401 S. Grand Ave. Santa Ana, CA 92705 (800) 211-2767 www.twobros.
PAGE 2
Selecting the Map Position The Juice Box Pro comes loaded with up to ten maps. Using a #1 Phillips screwdriver, turn the map select dial to toggle between the loaded maps. Refer to the map position table below for the maps included in your Juice Box Pro. Using the RPM Range Dials The Low, Mid, and High RPM Dials refer to the RPM range, in thirds, of your vehicle. Each dial allows +/- 10% fuel adjustment on top of what fuel changes are done in the map.
PAGE 3
Juice Box Pro harness The ignition must be turned OFF before installation. Figure A 1 2 3 4 5 Remove the main seat. Lift the front of the fuel tank up. Temporarily place the Juice Box Pro in the vicinity of the tool kit. Route the wiring harness from the Juice Box Pro towards the front of the air box on the left hand side of the bike. Route the harness between the fuel tank and the frame as shown in Figure A. The fuel tank bracket will need to be loosened to fit the connectors through.
PAGE 4
Figure D 9 Route the ground wire to the right hand side of the throttle bodies. 10 Continue routing the ground wire under the frame cross member and above the radiator. 11 Attach the ground wire from the Juice Box Pro to the negative side of the battery as shown in Figure D. ground wire 12 Using the supplied velcro, secure the Juice Box Pro in the tool kit tray as shown in Figure E. Figure E Make sure to clean both surfaces with the alcohol swab before attaching.