Owner's manual

ITBR001-156
2006-09 Yamaha FJR1300 - 3
Figure AFigure BFigure C
Juice Box Pro
harness
unplug
The ignition must be turned OFF before installation.
1 Remove the main seat.
2 Lift the front of the fuel tank up.
3 Temporarily place the Juice Box Pro in the vicinity of the tool kit.
4 Route the wiring harness from the Juice Box Pro towards the front of the air box on
the left hand side of the bike.
5 Route the harness between the fuel tank and the frame as shown in Figure A.
The fuel tank bracket will need to be loosened to fit the connectors through.
6 Pull the heat shield located on top of the air box back to expose the wiring harness.
7 Unplug the stock connector from the throttle bodies to the main wiring harness as
shown in Figure B.
8 Attach the connectors from the Juice Box Pro to the throttle body and the stock
wiring harness as shown in Figure C.