Manual

Part 6
MIDI
Your TORPEDO Live can receive MIDI PROGRAM CHANGE (PC) and CONTROL CHANGE (C) commands sent by
any kind of MIDI controller connected to the MIDI IN of the machine.
It is important to setup the TORPEDO Live so it will be listening to the MIDI control
commands. Please refer to part 5.6 of this manual.
1 PROGRAM CHANGE (PC)
Each preset on the TORPEDO Live has a single program number. The preset 01 of the machine is triggered by a
MIDI PC 00, you can address the 100 presets (from 01 to 00 meaning 100), with MIDI PC 00 to MIDI PC 99. This
way, it is possible to randomly access the preset by sending the appropriate MIDI PC number.
2 CONTROL CHANGE (CC)
The following table contains the assignment of the parameters of the machine and the MIDI CC numbers and
values. It is important to setup the TORPEDO Live so it will receive MIDI control change.
Two Notes Audio Engineering TORPEDO Live 29