Installation Guide

D-308495 PGP914 Rev.0
Figure 2: Optimizing detection and avoiding false alarms
For more information refer to About PGP914.
1. Do not install near high-voltage electrical lines.
2. Keep away from heat sources.
3. Do not install outdoors.
4. Avoid direct sunlight.
5. Do not expose to air drafts.
6. Do not install behind partitions.
7. Do not mount on an unstable surface.
8. Install the device on a solid and stable surface at a height of 1.8 m to 2.4 m (6 ft. to 8 ft.)
Warning! Do not obscure partially or completely the device's field of view.
Enrolling the device
1. Refer to the control panel installation manual for the complete set of enrollment instructions
and testing procedures.
2. From the Installation menu, enter the Device enrollment menu and select the option to add
a new device.
3. Remove the battery pull-tab to power on the device and begin the auto-enrollment process.
If the battery pull-tab is not available or if the device does not automatically enroll, open the
device cover to trigger the enrollment. Alternatively, press the enroll button until the yellow
LED light turns on.
4. If requested, enter the PIN code printed on the device label.
5. To manually enroll the device:
a. Scan the QR Code on the device box, using the IQ4 camera if available, or see step b.
b. Manually enter the device ID, printed on the product label, in the format ID:125-xxxx.
Note: If the device has been powered up for more than 2 hours it will be identified by
the system only after the device has been reset.
The PGP914 is enrolled with device ID 125-XXXX. In fall back mode it enrolls as PGx914 with
device ID 126-XXXX.
6. Select the desired zone.
7. Configure any device parameters that are required.
8. Mount and test the device. See Local diagnostics test for information on testing the device.
Configuring the device parameters
1. Enter the DEVICE SETTINGS menu and follow the configuration instructions for the device as
described in the following table.
2 PGP914 Wireless PIR Motion Detector Installation Guide