Installation Guide

D-308495 PGP914 Rev.0

Figure 4: Closing the device cover

Installing the pet mask

Install the pet mask if you require pet immunity. For pet rejection, the optimal installation height is

2.1

m (7 ft.). Pet immunity is up to 38 kg (85 lb).

Note:

Pet immunity is not supported at heights of 2.4 m (7.87 ft.) and above. Do not install the

pet mask if you are mounting the device at this height or above.

Insert the tabs at the base of the pet mask into the holes below the PIR sensor. See A1 in the

following figure.

Align the tabs on the sides of the pet mask with the holes on either side of the PIR sensor. See

A2 in the following figure.

Press down gently to install the pet mask.

Figure 5: Installing the Pet Mask

Close the device cover. See Figure 4.

6 PGP914 Wireless PIR Motion Detector Installation Guide