Installation Guide

D-308495 PGP914 Rev.0
Figure 7: Double-sided adhesive tape placement on the bracket
3. Mount the bracket on the wall. For flat bracket see Figure 8. For corner bracket see Figure 11.
4. Align the device with the bracket. See A1 in the figure below.
5. Slide the device upward until a click is heard. See A2 and A3 in the figure below.
Figure 8: Attaching the device to the bracket
Mounting the device using screws
About this task:
Note: Mounting using screws is required for UL/ULC commercial burglary and residential fire
type installations. Wall tamper (break-away segment) shall also be enabled.
1. Screw the bracket onto the wall.
Note:
Make sure to fasten the break-away segment to the frame. If the device is forcibly
removed from the wall, this segment will break away from the base, causing the tamper
switch to open.
8 PGP914 Wireless PIR Motion Detector Installation Guide