Users Manual
Table Of Contents
- Contents
- Safety instructions
- Introduction
- Electrical ratings
- Installing the equipment
- Enrolling the module
- Enrolling devices
- Attaching the cover
- Status LEDs
- Troubleshooting
- FCC and ISED Canada Information
- FCC class B digital device notice
- UL and ULC notes
- European CE Compliance and CERTALARM Certification
- EULA
- Limited warranty
Wiring the power supply
To wire the external power supply, complete the follow steps:
1. On the power supply, secure the wires to the terminals.
2. Insert the cable through the back of the enclosure.
3. Connect the wires to the 18 VDC terminals on the PCB.
Wiring the battery
To wire the battery, complete the following steps:
1. Connect the red battery lead to the positive terminals on the PCB and the battery.
2. Connect the black battery lead to the negative terminals on the PCB and the battery.
Figure 4: Wiring the battery
+
-
-
+
-
+
Enrolling the module
Before you enroll the module, ensure that all hardwired zones, PGM, AUX, and BELL are wired to the
module.
Note: The format of the device ID is XXX-YYYY where XXX identifies the type of device and
YYYY is used by the system to identify the specific device.
9PG8WLSHW8 and PG9WLSHW8 PowerG Wired to Wireless Converter