Users Manual

Safety instructions
Read the safety information before you install the equipment.
Note: This equipment must be installed by a skilled person only. A skilled person is an installer
with appropriate technical training. The installer must be aware of potential hazards during
installation and measures available to minimize risks to the installer and other people.
• Before you install this equipment, disconnect all power sources (for example mains, battery, and
telephone line) connected to the alarm panel.
• Install the equipment indoors in a non-hazardous environment where the following conditions
are met:
- Pollution degree - Maximum 2
- Over voltages - Category II
• Internal wiring must be routed to prevent strain on wire and terminal connections, loose
terminal connections, and damage to conductor insulation.
• Instruct the user that there are no user serviceable parts in this equipment. All equipment must
be serviced by a skilled person.
Introduction
The PowerG Wired to Wireless Converter converts existing hardwired zones to PowerG wireless
zones.
There are two models, the PG8WLSHW8 and PG9WLSHW8, and each provide eight hardwired zones
and four programmable outputs. This document describes how to mount the enclosure, wire zones,
connect the battery, enroll devices, and troubleshoot.
Note: Only PG9WLSHW8 is UL and ULC listed. For UL and ULC installations, use this device only
in conjunction with compatible wireless receiver and control panel combinations, model Qolsys
IQPanel2.
Before you begin, make sure that the kit contains the following items:
• The plastic enclosure containing the PowerG Wired to Wireless Converter
• The transformer
• The hardware pack
Electrical ratings
The following table outlines the electrical ratings of the components of the PowerG Wired to
Wireless Converter:
3PG8WLSHW8 and PG9WLSHW8 PowerG Wired to Wireless Converter