Users Manual
Table Of Contents
- Contents
- Safety instructions
- Introduction
- Electrical ratings
- Installing the equipment
- Enrolling the module
- Enrolling devices
- Attaching the cover
- Status LEDs
- Troubleshooting
- FCC and ISED Canada Information
- FCC class B digital device notice
- UL and ULC notes
- European CE Compliance and CERTALARM Certification
- EULA
- Limited warranty
Table 1: Electrical ratings
Output Rating
DC input voltage and current
18 V DC, 2.2 A.
Manufacturer: ShenZhen SOY Technology Co.
Ltd. Model: SOY-1800222-NA
Battery charging voltage and current 13.7 V DC, 500 mA
Bell circuit voltage and current
11.5 V DC to 12.5 V DC, maximum current 700
mA continuous
Auxilliary power voltage and current
11.5 V DC to 12.5 V DC, minimum current 700
mA
Note: For 24 hour standby, the AUX current
must not exceed 180 mA.
PGM 1, 3, and 4 voltage and current 11.5 V DC to 12.5 V DC, 50 mA
PGM 2 voltage and current 11.5 V DC to 12.5 V DC, 300 mA
Operating temperature -10°C to 55°C
Humidity
5% to 93% RH non-condensing
Note: The PGM outputs are shared with the AUX terminals.
Installing the equipment
This section describes how to mount the enclosure, install the battery, and wire the system.
The enclosure has three breakaway tabs that you can use for wiring access during installation.
There are also two slots for the battery strap to pass through. For more information, see the
highlighted areas in Figure 1.
Note: Remove the breakaway tabs only if required.
PG8WLSHW8 and PG9WLSHW8 PowerG Wired to Wireless Converter4