User's Guide

ZBAMB2070 MOBILE HANDHELD DEACTIVATOR 8200-0958-05, REV. A
INSTALLATION AND USER GUIDE
2 of 5
Using the Device
1. Remove the scanner/deactivator
from the Motorola Base Charging
Station.
2. Aim the scanner at the barcode and:
a) Pull the trigger. The scanner will
beep indicating a successful
scan.
b) Release the trigger; the LEDs on
the deactivator will flash yellow
for 3 seconds. Within this
window, perform step 3.
(If you were unable to perform
step 3 within this window, repeat
step 2.)
3. Swirl the deactivator coil in 2.54cm
(1in) circles no more than 11.4cm
(4.5in) from the barcode. Observe
deactivation indications.
Deactivation Indications
LEDs / Audio Indicates
Green flash +
1 beep
Deactivation successful
Red flash +
3 beeps
Deactivation failed
4. When finished, seat the
scanner/deactivator firmly into the
Motorola Base Charging Station to
maintain the battery charge.
Fault Indications
LEDs / Audio Indicates
Flashing red
and yellow
Replace the battery.
Red flash +
beep every
500ms until 30
seconds has
elapsed
Deactivator is out of
range of the Sync AP
device.
Solid red Replace the
deactivator.
IIIIIIIIIIIIIIIIIIIII
IIIIIIIIIIIIIIIIIIIII