Install Guide

Preliminary
ZBAMB9010-IPS EAS LABEL DEACTIVATION CONTROLLER 8200-0747-24 REV. 3A
INSTALLATION GUIDE
2 OF 7
Deactivation pads and coils used with
the controller:
Deactivation
Pad
Consists of one or two coils
inside a horizontal housing
Deactivation
Coil
A vertical or horizontal coil in
a standalone housing or
inside a barcode scanner
Note: This controller has been approved for use
with high inductance ScanMax Pro deactivation
pads, although not presently offered.
High Inductance Pads (ScanMax Pro)
Pad
Tx Power
ZBSMPLP (LP Pro)
Med
ZBSMPPP (PowerPad Pro)
Med
ZBSMPSP (SlimPad Pro)
Med
ZBSMPIP (IP Pro)
Med
ZBSMPCP (CompactPad Pro)
Med
Scanner Integrated High Inductance Coils
Coil
Tx Power
ZBSMPIS (ScanMax IS)
Med
ZBSMPNS2 (ScanMax NS2)
Med
ZBSMPHS (ScanMax HS)
Med
ZBAMB5110H, ZBAMB5110V
Med
ZBAMB5220A
High
ZBAMB5278A
Med
Low Inductance Pads / Coils
Coil / Pad
Tx Power
ZBAMB5010A Coil
Low
ZBAMB5011A Pad
Low
ZBAMB5012A Pad
Low
ZBAMB5182A Coils*
Low
ZBAMB5184A Coil*
Low
ZBAMB5185A Coil*
Low
ZBAMB5190A Coil*
Low
ZBAMB5274H, ZBAMB5274V Coils*
Low
ZBAMB5300A Coil*
Low
ZBAMB5780 Coil
Low
* Scanner integrated.
Internal features:
 Automatic deactivation coil detection
 Auto and re-synchronization
 Adjustments to transmit and deactivation fields
 Status LED for power on, communication
activity, and basic diagnostics.
 EAS Label type (SR/DR).
Front panel features:
a. Tie wrap slot. A tie wrap helps keep the power
cord from being accidentally disconnected from
the controller.
b. Power: AC power cord connects here.
c. RS-485 (Network) ports: Two 8-position
modular jacks provide RS-485 communication
between Sensormatic devices and a POS
system.
d. Status LED: Indicates deactivation status.
Status indications are mentioned in the setup
guides for the controller, pads, and coils.
e. Service port: This 4-position modular jack
provides RS-232 communication to a laptop
computer for advanced setup and diagnostics.
f. Scanner port: This 8-position modular jack
allows a POS system, such as a barcode
scanner, to control deactivation and also
provides RS-232 communication if required.
These ports accept various control voltages
(see specs on page 6).
g. Remote port: This 6-position RJ-11 modular
jack supports the ZPSTP-RA Remote Alarm
Module. Deactivation can be disabled on this
port.
h. Pad or coil cable port: The EEPROM cable
from the deactivation pad or coil plugs into this
port. The preprogrammed EEPROM enables
the controller to automatically identify the pad or
coil and adjust its parameters accordingly. If the
EEPROM is not programmed, controller settings
default to the PowerPad Pro deactivation pad.
a
b
c
e
f
g
h
d