Install Guide

Preliminary
ZBAMB9010-IPS EAS LABEL DEACTIVATION CONTROLLER 8200-0747-24 REV. 3A
INSTALLATION GUIDE
3 OF 7
Setup
A Deactivation Universal Configurator is used to
setup the controller. This configurator:
 Installs on a laptop computer that plugs into the
SERVICE port.
 Requires Microsoft
®
Windows
®
XP operating
software on the laptop.
Auto Detection
Auto detection enables the controller to adjust to
the deactivation pad or coil in use.
Synchronization
Auto synchronization. Upon power up, the
controller automatically syncs its transmission to
other nearby EAS systems, after which auto sync
is disabled.
Resynchronization. Enabled using the software
configurator, resynchronization enables the user to
manually force the controller to resync its
transmission to other nearby EAS systems.
Wired synchronization. The Universal Sync
standard (wired sync) is supported on the
NETWORK port as either transmit or receive
mode, and is set up in the software configurator.
POS Integration
A dedicated scanner port enables POS integration.
POS devices such as barcode scanners can
control deactivation when connected to the
scanner port.
 POS devices must be programmed with special
software.
 Voltage specifications are on page 6.
Networking
A network port provides the ability to enable an
external Sensormatic device such as an LDM II to
send data to a store’s POS network using the RS-
485 port for the purpose of remote diagnostics or
data mining. The external device must be
programmed with special software.