Install Guide

Preliminary
ZBAMB9010-IPS EAS LABEL DEACTIVATION CONTROLLER 8200-0747-24 REV. 3A
INSTALLATION GUIDE
7 OF 7
Declarations
Regulatory Compliance
Pad/Coil
Regulatory ID
ZBSMPLP
DEAC STP-LP
ZBSMPPP
DEAC STP-PD
ZBSMPCP, ZBSMPCP-F
DEAC STP-CD
ZBSMPSP
DEAC STP-SD
ZBSMPIP
DEAC STP-SD
ZBSMPIS
DEAC STP-JD
ZBSMPNS2
DEAC STP-JD
ZBAMB5010A
AMB-5010
ZBAMB5010A2
AMB-5010
ZBAMB5011A
AMB-5011
ZBAMB5012A
AMB-5012
ZBAMB5110H, ZBAMB5110V
AMB-5110
ZBAMB5182A
AMB-5182
ZBAMB5184A
AMB-5184
ZBAMB5185A
AMB-5185
ZBAMB5190A
AMB-5190
ZBAMB5220A
AMB-5220
ZBAMB5274H, ZBAMB5274V
AMB-5274
ZBAMB5278A
AMB-5278
ZBAMB5300A
AMB-5300
ZBAMB5780
AMB-5780
EMC ........................................................ 47 CFR, Part 15
EN 55022
EN 55024
ICES-003
Safety (2
nd
Edit.) ............................................ UL 60950-1
CSA C22.2.60950-1
EN 60950-1
EMC ........................................................ 47 CFR, Part 15
RSS 210
EN 300 330
EN 301 489
Safety ............................................................ UL 60950-1
CSA-C22.2.60950-1
EN 60950-1
Environmental rating: ................................................ IP20
FCC COMPLIANCE: This equipment complies with Part 15 of
the FCC rules for intentional radiators and Class A digital
devices when installed and used in accordance with the
instruction manual. Following these rules provides reasonable
protection against harmful interference from equipment
operated in a commercial area. This equipment should not be
installed in a residential area as it can radiate radio frequency
energy that could interfere with radio communications, a
situation the user would have to fix at their own expense.
FCC COMPLIANCE: This equipment complies with the limits
for a Class B digital device, pursuant to Part 15 of the FCC
rules. These limits provide reasonable protection against
harmful interference in a commercial or residential installation.
This equipment can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may
cause harmful interference. If this equipment does cause
harmful interference to radio or television reception, which can
be determined by turning the equipment off and on, the user is
encouraged to correct the interference by one or more of the
following: reorient or relocate the receiving antenna, increase
the separation between the equipment and receiver, connect
the equipment on a circuit different from that to which the
receiver is connected, consult the dealer or an experienced
radio/TV technician for help.
EQUIPMENT MODIFICATION CAUTION: Equipment changes
or modifications not expressly approved by Sensormatic
Electronics, LLC, the party responsible for FCC compliance,
could void the user's authority to operate the equipment and
could create a hazardous condition.
Other Declarations
WARRANTY DISCLAIMER: Sensormatic Electronics, LLC
makes no representation or warranty with respect to the
contents hereof and specifically disclaims any implied
warranties of merchantability or fitness for any particular
purpose. Further, Sensormatic Electronics, LLC reserves the
right to revise this publication and make changes from time to
time in the content hereof without obligation of Sensormatic
Electronics, LLC to notify any person of such revision or
changes.
LIMITED RIGHTS NOTICE: For units of the Department of
Defense, all documentation and manuals were developed at
private expense and no part of it was developed using
Government Funds. The restrictions governing the use and
disclosure of technical data marked with this legend are set
forth in the definition of ―limited rights‖ in paragraph (a) (15) of
the clause of DFARS 252.227.7013. Unpublished - rights
reserved under the Copyright Laws of the United States.
TRADEMARK NOTICE: ScanMax and Sensormatic are
registered trademarks of Sensormatic Electronics, LLC. Other
product names mentioned herein may be trademarks or
registered trademarks of Sensormatic or other companies.
No part of this guide may be reproduced in any form without
written permission from Sensormatic Electronics, LLC.