User's Manual

AMS-1080 DETECTION SYSTEM 8200-0418-01, REV. A
INSTALLATION AND SERVICE GUIDE
12 of 18
Controller Installation
Tools required:
- Tape measure
- Pencil or marker
- Electric drill and drill bits: 5.5mm (7/32in) and 9.5mm
(3/8in)
- Phillips-head screwdriver or bit
- Hand vacuum or broom
Parts required:
Install Kit 0352-0203-01
Screw, self-drilling, M4, 8x25, PHP 4 5899-0031-01
PROCEDURE
1. Set the controller on a shelf or mount it, with its
fan facing down, to a vertical surface using the
four self-drilling screws supplied.
WARNING! The vertical surface must
be able to support 13.3kg (29.4 lbs).
2. Referring to the diagram on page 4, attach
connectors to cables used for the installation.
3. Plug cables into the appropriate
connectors on the controller.
AC Hookup
CAUTION: Fan voltage is factory set
for 240Vac. If using 120Vac, remove the
cover from the controller and change fan
jumpers to 120Vac. See label inside the
controller for jumper locations.
PROCEDURE
1. Choose a power cord for the country of use.
Power cords come in .9m (3ft), 2.7m (9ft), 3.7m
(12ft), and 4.6m (15ft) lengths.
2. Plug in the power cord. The controller
automatically senses the voltage (100-120Vac
or 200-240Vac). No adjustments are required.
WARNING—RISK OF ELECTRIC
SHOCK! The ac power cord may carry
120Vac or 240Vac.
CAUTION: When using a power cord,
a socket-outlet must be installed near
the controller and in an easily
accessible location.
Für Installationen mit einem Stromkabel
muß die Steckdose an einem Standort
installiert werden, welcher einfachen
Zugang erlaubt.
CAUTION: A 10A, 2-pole, ganged
disconnect device, which also provides
short circuit and overload protection,
and has a minimum 3mm open circuit
clearance, in accordance with the
National Electric Code and applicable
local codes must be installed by a
licensed electrician at a location readily
accessible to the equipment.
Ein 10A, 2-poliges, gekoppeltes
Ausschaltgerät, welches auch über
einen Kurzschluß- sowie
Überbelastungsschutz verfügt, und
einen minimum 3mm offenen
Schaltabstand aufweist, nach
Übereinstimmung mit den Nationalen
Elektrischen Regelungen sowie
lokalen Regeln, muß an einem
Standort installiert werden, welcher
einfachen Zugang zum Gerät erlaubt.