Install Guide

Preliminary
AMS-9030 CONTROLLER 8200-0344-02, REV. 0
INSTALLATION GUIDE
3 of 16
Controller
G The controller can be placed on a shelf or
mounted on a wall. It can be hidden in a
remote location such as a back room or
basement.
G Provide a minimum of 20cm (8") of
unobstructed space around the controller for
ventilation.
G Use the appropriate power cord based on the
country of use.
USA-IEC 320, 18/3, 125V, 10A, 7.5ft. 0351-0547-01
Schuko-IEC 320, 1mm sq., 250V, 10A, 2.5m 0351-0547-02
UK-IEC 320, 1mm sq., 250V, 10A, 2.5m 0351-0547-03
Japan-IEC 320, 2mm sq., 250V, 15A, 2.5m 0351-0547-04
US-Filter, Line, 125V, 6A, Plug-in 0351-0547-05
Australia to IEC 320, 2.5m, 250V, 10A 0351-0547-07
G Replace the slow-blow fuses only with a fuse
of the same type and rating.
G Maximum cable distance from the antennas to
the controller is 12.2m (40').
ZC30-ADS/ZC35-ADS Remote Alarm Unit
G If the system uses a transformer to power the
remote alarm, plug the transformer into a 24-
hour, unswitched outlet.
G Maximum cable distance from the controller to
each alarm unit is about 7.6m (25').
Tools and Equipment Required
For all controller installations:
• Hammer
• Phillips and slotted screwdrivers, including a
tweaker for the terminal block screws
• Wire strippers
• Pliers
• Cordless drill and phillips-head screwdriver bits
• Vacuum and broom
Mounting the Controller
The controller can rest on a shelf, which requires
no mounting procedure. It also can be mounted in
a ceiling or on a wall, which requires a mounting
bracket. If the controller is mounted in a ceiling that
is used for return air (environmental “other air
space”), an air handling option kit is required.
• Shelf-mounting – ensure the controller has
20cm (8”) clearance on all sides.
• Mounting controller to bracket – attach the
mounting bracket to the wall, ceiling, or counter.
To mount the controller to a wall:
1. Using the mounting bracket as a template,
mark four holes on the wall.
CAUTION: The mounting bracket can be
oriented vertically or horizontally, but it
must not be mounted with the keyholes
on the flanges upside, down as shown
below.
Keyhole
Flanges