Install Guide

Preliminary
AMS-9030 CONTROLLER 8200-0344-02, REV. 0
INSTALLATION GUIDE
5 of 16
CAUTION: Do not connect ferrite
receivers (for example, Rangers, Satellite
receivers) to the transceiver connectors
P13 and P16. They must only be
connected to receiver ports P22 and P23.
CAUTION: Do not plug antennas into
controller while the controller is on. Doing
so can damage the power amplifier or
power supply chip in the controller.
WARNING: RISK OF ELECTRIC
SHOCK! Do not adjust tuning jumpers
while controller is on. Doing so can
expose you to ac voltage and damage
the controller.
Connecting to P15 and P18
Connectors P15 and P18 are the Communication
connectors for antennas compatible with Ultra*Post
Plus antennas. Ultra*Post compatible antennas
can be divided into three categories: those with
12V alarm lamps, those with 5V alarm lamps, and
antennas without alarm lamps. The tables below
list the antennas that are compatible with the AMS-
9030 and which type of antenna they are.
Table 1. +12V Lamp antennas
ZSDDM DoorMax Antenna
Table 2. +5V Lamp antennas
ZSEMPLUS EuroMax Plus Pedestals
ZSEPPLUS MegaMax Plus Pedestal
ZSDPMPLUS Digital Pro-Max Plus
Pedestal
Table 3. No alarm lamp antennas
ZAUPSH2 Ultra*Post Non-Alarming,
Non-European
ZSDFMPLUS2-A AMS-2001 (FloorMax) (12m)
ZSDFMPLUS2-A18 AMS-2001 (FloorMax) (18m)
ZSLOOP-2E Loop antenna Kit
The following two tables show how to connect the
+5V and +12V antennas; antennas without alarms
do not connect to P15 and P18. Note that
depending on how the controller motherboard has
been configured, pin 3 provides either +5v or +12V
for the antenna alarm lamp.
Table 4. +5V style pinouts
Pin Signal Wire Color
1 Audio + Orange
2 Audio Return Red
3 +5V Lamp Yellow
5 Ground Grey
10 Shield Shield
Table 5. +12V style pinouts
Pin Signal Wire Color
1 Audio + Black
2 Audio Return Brown
3 +12V Lamp Red
4 Not used Orange
5 Ground Yellow
6 Ant. A RS232 Rx Green
7 Ant. A RS232 Tx Blue
8 Not Used Violet
9 +15V Gray
10 Shield Shield