User's Manual

AMS-9040 CONTROLLER 8200-0367-02, REV. D
INSTALLATION AND SERVICE GUIDE
14 of 22
System Setup
The AMS-9040 controller requires field personnel
to setup the controller for the environment. For a
successful installation, follow the two rules below:
Rule 1: Each channel transmits through one
Tx/Rx antenna at a time. As shown below, if two
Tx/Rx antennas must transmit simultaneously, they
can do so when connected to channels A and B,
A and D, C and B, or C and D.
Transmitter Multiplexing
Rule 2: As shown below, each input on the
controller has an address associated with it; Ant. A
has address 0; Ant. B has address 1, and so on up
to address 7. For the controller to operate properly,
each intelligent Tx/Rx antenna must be set to
match the address of the input it is plugged in to.
Receiver Multiplexing
PROCEDURE
1. Ensure the controller is off.
2. Connect antenna Tx/Rx cables to the controller
according to how the antennas are intended to
perform. If the antenna is intelligent, set the
rotary switch on its cap board to match the
address on the controller for the Rx input. See
examples below for how to connect antennas
for typical installations.
– Two doorways each have a pair of intelligent
Tx/Rx antennas and each pair is to transmit
simultaneously.
Doorway 1 Doorway 2
Connector
on Controller Address
Connector
on Controller Address
Tx/Rx A 0 Tx/Rx C 2
Tx/Rx B 1 Tx/Rx D 3
– Two doorways each have three intelligent
Tx/Rx antennas. The center antenna is to
transmit and receive and the outboard
pedestals are to receive only (split system).
Doorway 1 Doorway 2
Connector
on Controller Address
Connector
on Controller Address
Rx Aux A 4 Rx Aux C 6
Tx/Rx A 0 Tx/Rx B 1
Rx Aux B 5 Rx Aux D 7
– Two intelligent Tx/Rx antennas at the sides
of a doorway with two Floor-Max antennas
between them (combo system).
Antenna
Type
Connector
on Controller Address
Tx/Rx Tx/Rx A 0
Floor-Max Tx/Rx B 1
Floor-Max Tx/Rx C 2
Tx/Rx Tx/Rx D 3
– One doorway has two intelligent antennas;
one transmits, the other receives.
Connector
on Controller Address
Tx/Rx A 0
Rx Aux A 4
Antenna A
Antenna B
Aux A
Aux B
Cross-Point
Switch
Rx Channel
Rx Channel
Rx Channel
Rx Channel
Antenna C
Antenna D
Aux C
Aux D
Cross-Point
Switch
DSP
Rx Channel
Rx Channel
Rx Channel
0
1
4
5
2
3
6
7
Antenna Address
Rx Channel
Tx Channel 1
Antenna A
Antenna C
Antenna B
Antenna D
Antenna A/C
Select
Output
Select
Antenna B/D
Select
Output
Select
Tx Channel 2