User's Manual

Special Rules for Floor
Antennas
Floor-Max Antennas
Follow these five rules for Floor-Max antennas:
Rule 1: In Europe, two Floor-Max antennas must
transmit simultaneously. When on the configurator,
“European System” is selected on the “Setup”
page, simultaneous operation is automatically
selected.
Rule 2: When two Floor-Max antennas are used
in a single doorway, both cap boards must share a
single box, and a single key switch must control
both antennas. The switch must connect to the
lowest letter antenna. For example, two Floor-Max
antennas (A and C) are in the same doorway.
Connect the switch to A.
Rule 3: When three Floor-Max antennas are
used in a single doorway, cap boards for antennas
A and B must share a single box, and a single key
switch must control both antennas. The switch
must connect to the lowest letter antenna. For
example, for Floor-Max antennas (A and B),
connect the key switch to A. The cap board for
antenna C will be in a box by itself with its own
switch.
Rule 4: When four Floor-Max antennas are used
in a single doorway, cap boards for antennas A
and B must share a single box, and cap boards for
antennas C and D must share a single box. Two
key switches, one per box, are used with each
switch connected to the lowest letter antenna.
Switch 1 controls antennas A and B and must
connect to antenna A. Switch 2 controls antennas
C and D and must connect to antenna C.
AMS-3030 and AMS-3031 Floor
Antennas
Follow these rules for AMS-3030 and AMS-3031
Floor antennas that have a key switch installed:
Rule 1: When two Floor antennas are used in a
single doorway, both cap boards must share a
single box, and a single key switch must control
both antennas. The switch must connect to the
lowest letter antenna. For example, two Floor
antennas (A and C) are in the same doorway.
Connect the switch to A.
Rule 2: When three Floor antennas are used in a
single doorway, cap boards for antennas A and B
must share a single box, and a single key switch
must control both antennas. The switch must
connect to the lowest letter antenna. For example,
for Floor antennas (A and B), connect the key
switch to A. The cap board for antenna C will be in
a box by itself with its own switch.
Rule 3: When four Floor antennas are used in a
single doorway, cap boards for antennas A and B
must share a single box, and cap boards for
antennas C and D must share a single box. Two
key switches, one per box, are used with each
switch connected to the lowest letter antenna.
Switch 1 controls antennas A and B and must
connect to antenna A. Switch 2 controls antennas
C and D and must connect to antenna C.
AMS-9040 CONTROLLER 8200-0367-02, REV. D
INSTALLATION AND SERVICE GUIDE
16 of 22