User's Manual
Table Of Contents
- AMS-9050 Controller
- Contents
- To the Installer
- About the Product
- Installation Features
- Setup Features
- Service Features
- Basic Operation and Setup
- Device Connections
- Installation Features
- Service Features
- - The service configurator displays the operating current for each antenna. Operating current is 15A peak for all countries.
- - The service configurator displays ambient temperature within the controller.
- - The hardware supports software with a remote command to reset the system.
- - Hardware within the controller protects it from runaway software.
- Installation Requirements
- Controller Installation
- Troubleshooting
- Fuse Replacement
- Specifications
- Declarations
- AMC-7000 Integrated Metal Foil Detection
- About this Guide
- About the Product
- Installation
- Specifications
- Declarations
Preliminary
AMC-7000 Integrated
Metal Foil Detection
Installation Guide
ZPMETAL-DET
About this Guide
This installation guide explains how to install the
AMC-7000 Integrated Metal Foil Detection kit
(ZPMETAL-DET). The AMC-7000 is an option for
AMS-9050 controllers connected to dual 2m
Ultra•Exit antennas (ZS1090, ZS1091, and
ZS1102) with the Integrated Traffic Flow option
(ZPUE-TRAFFICNTR). Other related documents
are:
• Installation and Service Guide, AMS-9050
Controller, 8200-0537-02
• Installation Guide, Ultra•Exit Transceiver
Antennas, 8200-0537-16
Note: Because customer requirements dictate the
placement of system components, your
Sensormatic representative will supply this
information separately.
About the Product
The AMC-7000 Integrated Metal Foil Detection kit
(ZPMETAL-DET) is an AMS-9050 option that
detects metal with a large surface area, such as
aluminum foil, when it passes between the
pedestals of a system. It is designed to not detect
metal objects with small continuous surfaces, such
as keys and shopping carts. The kit can only be
used with AMS-9050 controllers and only for dual-
pedestal 2m systems.
AMC-7000
The AMC-7000 consists of the following:
• a circuit board housed in a metal enclosure
• cabling and associated connectors
• mounting brackets and associated hardware
AMS-9050
Controller
Features
• Automatic Detection Adjustment – the system
adjusts itself to changes in the amount of metal
in the environment.
• Enclosure is suitable for use in environmental
air handling space other than ducts or plenums.
• Directional Inhibit support – using the People
Counter option, system can be set to alarm for
incoming metal only, out-going metal only, or
both.
• Multiple alarm methods – the system can
indicate the presence of metal by several
methods: a visual alarm at the pedestal, an
audio alarm at the pedestal, the triggering of a
relay that connects to another device (such as a
paging system), or an alarm at a digital remote
alarm.
• Metal foil detection counts – the number of
metal foil detections can be displayed on an
optional Local Device Manager (LDM).
• Low power requirements – can be powered by
Alarm output of AMS-9050 controller.
• Large coverage area – detects metal between
two 2m (6.5ft) antennas up to 1.5m (5ft) high.
• Wired synchronization – wired synchronization
of controller with other controllers must use
Universal Synchronization because the Wired
Synch port is needed for Metal Foil Detection.
© 2008 Sensormatic Electronics Corp.
AMC-7000 INTEGRATED METAL Foil DETECTION 8200-2609-01, REV. 3a
INSTALLATION GUIDE
17 OF 31