User's Manual

Preliminary
AMS-9060 CONTROLLER 8200-1014-01, REV. 1A
INSTALLATION GUIDE
3 of 13
Installation Requirements
Verifying Equipment and Unpacking
 Verify that all equipment has arrived. Ensure the
system configuration is correct for the site.
 Unpack major components in a back room. At
the install site, lay out parts in the order used.
Do not clutter the aisle or cause a trip hazard.
Installer/Contractor
 Have electrical work comply with the latest
national electrical code, national fire code, and
all applicable local codes and ordinances.
 Coordinate work with other trades to avoid
interference.
 Verify existing site conditions and coordinate
with the owner’s representative and appropriate
utilities as required.
 Obtain copies of all related plans, specifications,
shop drawings and addenda to schedule and
coordinate related work.
 Thoroughly review the project to ensure that all
work meets or exceeds the above requirements.
Bring alleged discrepancies to the attention of
Sensormatic Electronics.
Mounting Requirements
 The controller has a built-in flange used to
attach the controller to a wall or ceiling using
suitable hardware. Structure and hardware must
support 12.08kg (26.06 lbs) or four times the
weight of the controller assembly.
 Do not mount controller with its fan facing up.
AC Requirements
WARNING—RISK OF ELECTRIC
SHOCK! During installation, if the
antenna must be left unattended, turn off
power or cover high voltage components
to prevent unauthorized access to
hazardous voltages.
WARNING—RISK OF ELECTRIC
SHOCK! The ac power cord could be
carrying 120Vac or 240Vac.
WARNING! Do not install this device
where highly combustible or explosive
products are stored or used.
WARNING! The ac source must be a 2-
wire type with ground. It also must be a
24-hour, unswitched outlet with less than
0.5Vac between neutral and ground.
WARNING! This device is not suitable
for an IT power distribution system
where impedance exists between neutral
and protective earth contacts.
CAUTION: When using a power cord,
install a socket-outlet near the controller
in an easily accessible location. The
appliance coupler or plug on the power
supply cord are the specified disconnect
devices.
CAUTION: DO NOT share the ac source
with neon signs, motors, computers,
cash registers, terminals, or data
communications equipment.
CAUTION: DO NOT use orange-colored
outlets dedicated for computer
equipment.
CAUTION: Select the appropriate power
cord based on the country of use.
Mounting the Controller
The controller can be mounted as follows:
 On a shelf.
 On a wall.
 To a ceiling. Plywood with a surface larger than
the controller is secured to the ceiling studs that
hold the drywall. The controller then attaches
with suitable hardware to the plywood.
Equipment Required
Basic setup requires the following equipment:
 AMS-9060 controller
 Pedestal antennas
 Hard tag (non-deactivatable Ultra•Max tag)
 Ultra•Max low energy labels.
Advanced setup requires the following additional
equipment:
 Laptop with Windows
®
7, Windows
®
95,
Windows
®
98, Windows
®
NT, or Windows
®
2000,
operating software
 RS-232 Ultra•Max programming cable
 ADS 4 service configurator software.