User's Manual
Manuals
Brands
Tyco Safety Products/Sensormatic Manuals
Electronics
Access Control Reader
41
42
43
44
45
46
47
48
49
50
Table Of Contents
Introduction
Product Overview
Access Badges and Asset Tags
Handheld Reader
RF Readers
Antennas
RF Controller
RF Reader Configuration
Specifications
Electrical
Environmental
Regulatory
Basic Functionality
Basic System Operation
RF Controller Block
Synchronization Circuitry
Communications Interfaces
Planning
RF Passage Reader Configurations
Single-Antenna Configurations
Multiple-Antenna Configurations
Application-Specific Configuration Requirements
Coordinating with Software Features
Configuration Requirements
RF Passage Antennas
RF Controllers
Inputs
Outputs
Host Panel
RF Controller Power Supply
External Power (to Power Supply)
Cabling
Asset Tag
Access Control Badge
Tools and Equipment
Installation
Installation Checklist
Phase 1: Hardware Installation
Phase 2: System Activation and Test
Install Cable Runs
Install RF Passage Antennas
Prepare for Installation
Install brackets and Mount Antennas
Install Wire Loop for Antenna Pairs
Connect RF Controller Cables
Install Finishing Hardware
Install RF Controller
Prepare for Installation
Mount the RF Controller Enclosure
Connect RF Antenna Cables
Connect Inputs and Outputs
Connect Communications Cable
Connect Sync Cable
Connect RF Reader at Panel
Connect Power to RF€Controller
Connect Model CW-RID-1 to AC Power
Inspect Installation
Apply Power
Verify System Operation
Functional Test
Full System Test
Service
Parts List
RFID 56 Format
Tune RF Passage Antennas
_
Tuning Guidelines
Tuning Procedure
Set Tuning Jumpers
DIP Switch Settings
Troubleshooting Tips
Asset Tag Installation
Overview
Applying Adhesive Tape
Applying 3M 4475 Plastic Adhesive
Positioning Guidelines
Managing RF Passage Antenna Performance
Performance Overview
Environmental Conditions Affecting Performance
Cable/Line Interference
Antenna Loading
Antenna Interference
Antenna Performance
One Antenna, .9m (3ft)
One Antenna, 1.8m (6ft)
Before You Begin
Investigating Performance
Check for Obvious Sources of Interference
Check for Antenna Loading
Investigate Antenna Interference
Troubleshooting Tips
Existing Installations
Intermittent Interference
Multiple Sources of Interference
Improve Performance
Control Cable/Line Interference
Control Antenna Loading
Control Antenna Interference
Troubleshooting Procedures
Isolate an Antenna
Use a Communications Receiver
Required Equipment
Set Up the Receiver
Searching for Source of Interference
Install Cancellation Coils
Before You Begin
Required Equipment
Plan Wiring Configuration
Make Cancellation Coils
Make Antenna Coupling Loop
Prepare Antenna for Cancellation
Install Antenna Coupling Loop
Install Coils
Connecting One Coil
Connect Multiple Coils
Finish the Installation
5-8
8000-2803-01, Rev. 1/A
Service
1
...
...
44
45
46
47
48
...
...
62
