User's Manual

A-2 8000-2803-01, Rev. 1/A Asset Tag Installation
Overview
Asset tags are attached to external asset surfaces
using semi-permanent adhesive tape or
permanent plastic adhesive. Asset tags are
shipped in two ways depending on how they will
be attached. For semi-permanent applications, the
adhesive tape is applied to asset tags before
shipping—they are ready to install. For permanent
applications, you must supply your own adhesive.
The recommended adhesive is 3M 4475 Plastic
Adhesive.
The product codes for asset tags are as follows:
• Without adhesive VL-ATRW-1
• With adhesive VL-ATRW-2
Procedures are provided for both adhesive tape
and plastic adhesive application. Follow the
instructions for the type of adhesive you are using
at your site. Read through all these instructions
before you begin applying asset tags.
CAUTION: Once the adhesive has
set, removal of the tag from the asset
might permanently damage the asset
and/or tag.
Applying Adhesive Tape
1. Examine the asset to identify a suitable location
for tag application. Guidelines for selecting a
location are provided below.
2. Clean the surface of the asset using a clean
cotton swab with isopropyl (70%) alcohol or an
alcohol medical wipe. To avoid contamination
when applying the alcohol to the asset’s
surface, wipe in one direction only. Allow the
surface to dry completely.
3. Peel the liner from the tag’s adhesive.
4. Position the tag against the clean asset
surface. Apply uniform pressure to the tag,
making sure there is full contact between the
asset and the tag. Apply pressure for five
seconds.
CAUTION: Adhesive application requires
two hours to establish a permanent bond.
Do not disturb the asset or tag for two
hours.
5. Verify tag application after twenty-four hours.
Applying 3M 4475 Plastic
Adhesive
These instructions are supplemental to the
instructions supplied by the manufacturer of the
plastic adhesive. Follow the manufacturer’s
instructions for proper use and safety precautions.
1. Examine the asset to identify a suitable location
for tag application. Guidelines for selecting a
location are provided below.
2. Clean the surface of the asset using a clean
cotton swab with isopropyl (70%) alcohol or an
alcohol medical wipe. To avoid contamination
when applying the alcohol to the asset’s
surface, wipe in one direction only. Allow the
surface to dry completely.
3. Using a zigzag motion, apply the 4475 Plastic
Adhesive to the entire bottom surface of the
tag.
4. Position the tag against the clean asset
surface. Apply uniform pressure to the tag,
making sure there is full contact between the
asset and the tag. After the tag is positioned,
use a paper towel to wipe off excess adhesive.
Apply pressure for one to two minutes.
CAUTION: Adhesive application
requires two hours to establish a
permanent bond. Do not disturb the
asset or tag for two hours.
5. Verify tag application after twenty-four hours.
Asset Tag
!
!