User's Manual

Preliminary
AMC-4010 SYNCHRONIZATION MODULE INSTALLATION AND SERVICE GUIDE (8200-0183-01, REV. 03)
3 of 5
Setting Up a ReceiverSetting Up a Receiver
1. Mount each receive module:
• As high as possible and in a location near
the designated EAS device. The length of
the cable supplied determines the distance
the module can be from the device.
IMPORTANT! Ensure the module will be
within 60.1m (200 feet) of the transmit
module.
IMPORTANT! If mounting the module to a
mobile checkout stand, mount it on the
stand as high and as far away from
obstructions and metal as possible.
• In such a way that the two LEDs on the
module can be readily see from below.
Note: It is recommended to mount the
module to an electrical access pole of a
checkout counter by running a tie wrap
through the two key slots on the back of
the module and then running two additional
tie warps through the tie wrap and around
the pole (see box).
2. Using the cable supplied, connect the receive
module to the expansion port of the EAS
device.
3. Allow __ time for the modules to synchronize.
Verifying OperationVerifying Operation
Transmit ModuleTransmit Module
Look at the transmit module. The green LED
blinking with the red LED off is normal.
Receiver Module(s)Receiver Module(s)
Look at each receive module. The green LED
glowing steadily with the red LED off is normal.