User's Manual
Table Of Contents
- AMS-1070 Controller
- _
- About this Guide
- About the Product
- Installation Requirements
- Installing the Controller
- Connecting the Antennas and Remote Alarm Module
- Connecting the Noise Canceling Antennas
- Connecting to Relays in the Controller
- Connecting Power to the Controller
- Connecting a Service Laptop to the Controller
- Connecting a Modem to the Controller
- Connecting a Controller to an RS-485 Network
- Connecting a Modem to an RS-485 Network
- Specifications
- Declarations
AMS-1070 EMI SHIELD INSTALLATION GUIDE (8200-0127-12, REV. A)
1 of 1
AMS-1070 Controller
EMI Shield
Installation Guide
Two EMI shields are required. To install each
shield:
1. Run the unterminated cable through the slot in
the shield from the direction shown, and then
connect the cable ends to the cable connector
according to wiring diagrams in AMS-1070
Controller Install Guide 8200-0127-06.
2. Attach the shield to the controller using the four
screws supplied.
© Sensormatic 2002
EMI Shield