User's Manual

Preliminary
AMS-1070 CONTROLLER INSTALLATION GUIDE (8200-0127-06, REV. 0)
4 of 13
Installing the Controller
The controller can be mounted on a wall or rest on
a shelf (no mounting procedure required).
• To mount the controller on a wall, proceed
to the section below.
• Otherwise, go to “Connecting the
Antennas and Remote Alarm Module” on
page 5.
The pack may be mounted in any orientation
except one. Do NOT mount the pack with the
power cord and connectors on top. See Figure 3.
Figure 3. Wall mounting orientations
1. Unscrew the mounting plate from the
bottom of the controller.
2. Select the mounting method.
The mounting method must be able to support
24kg (53 lbs.) if both the controller and the
deactivator are mounted together and 12kg (27
lbs.) if the controller is mounted by itself.
Therefore, the controller should only be
mounted to metal or wood, not to hollow walls.
For wood or metal walls, you can use 10 x 1-
1/2” self-drilling phillips-head screws (P/N 5899-
0031-01).
3. Using a level, position the mounting plate on
the wall and mark the four mounting hole
locations.
4. Attach the mounting plate to the wall with
screws.
Figure 4. Attaching the mounting plate
5. Hang the controller onto the mounting plate
and slide it over to the left until it is secure,
as shown in Figure 5.
Figure 5. Attaching the controller to the
mounting plate
6. If the power pack for a ScanMax Pro
deactivator is nearby, you can use the
ScanMax Pro mounting plate (Figure 6) to
mount the deactivator to the top of the
controller to conserve space.
Refer to the AMS-1070/ScanMax Pro
Deactivator Mounting Plate Installation Guide
(8200-0127-14) for the installation procedure.
Figure 6. ScanMax Pro mounting plate
OK
NO!
O
K
OK