User's Manual

Configuring Modems for Use with Leased Lines
D-10 apC/8X Technical Manual
OEM HyperTerminal Edits for 4-Wire Leased Lines
From a HyperTerminal session, type the following commands:
Note: You must switch DIP Switch #10 to the UP position for your
HyperTerminal session to work properly. Ensure that after you
make these changes, you return DIP Switch #10 back to the
DOWN position.
It is normal to not see the commands as you type them. The only
response you will see in your session is after you press
<ENTER> following the list s-register command.
ALT6 <ENTER> Lists the S-registers.
S0 S2 S3 S4 S5 S6 S7 S8 S9 S10 S11 S13 S18 S19 S24 S25 S30
000 043 013 010 008 004 055 004 006 007 080 037 030 001 020 000 000
ATS18=0 <ENTER> Sets the ATS18 Register to 000
ATS19=0 <ENTER> Sets the ATS19 Register to 000
AT&W <ENTER> Stores the changes you just made to the
Registers
ATL6 <ENTER> Verify your 18 and 19 Registers are now
"000"
S0 S2 S3 S4 S5 S6 S7 S8 S9 S10 S11 S13 S18 S19 S24 S25 S30
000 043 013 010 008 004 055 004 006 007 080 037 000 000 020 000 000