User's Manual

Testing the apC/8X Installation
apC/8X Technical Manual B-3
10. Press the 3 key again. The green LED flashes slowly.
11. Press the 3 key again. The green LED flashes rapidly.
12. Press the 3 key again. The green LED goes out.
To test the outputs of the RM reader:
13. Press the 4 key. If an ARM-1 is connected to output 1 or 2, the relay(s)
should activate. Press the 4 key again to deactivate the relay(s).
Note: Pressing the 4 key activates both relay outputs on an RM reader.
To test the read head of the RM reader:
14. Press the 5 key to activate the card swipe test. The LEDs make no
response when the key is pressed.
15. Present a card. If it is a magnetic stripe reader, swipe in the forward
direction. The green LED lights up for two seconds. If the red LED
lights up, there is an error in the card read.
16. This step only applies to magnetic stripe read heads. Swipe the card in
the reverse direction. The amber LED lights up. If an error is read, the
red LED lights up.