User Manual

User’s Manual

TYCON TP-SSW5(-NC)

TYCON POWER SYSTEMS

*PD Port Wiring

Port 1 to 4 provide PoE inject function with maximum 35W(or 2A max.) ability to power up the

powered device use the straight-through or cross-over Ethernet cable.

The PoE switch follows the IEEE802.3af Alternative B mode connector assignment. The following

table shows pin assignment of alternative A and B for the Power Source Equipment.

Conductor

Alternative A

(MDI-X)

Alternative A

(MDI)

Alternative B

(All)

1 Negative Vport Positive Vport

2 Negative Vport Positive Vport

3 Positive Vport Negative port

4 Positive Vport

5 Positive Vport

6 Positive Vport NegativenVport

7 Negative Vport

8 Negative Vport

Be sure the twisted pair cable is bound with the standard RJ-45 pin, especially the pin 4, 5, 7 and 8.

If the RJ-45 is bound with the wrong pin number, PoE switch will not recognize the PD and won’t

deliver DC power to PD. The yellow PoE LED will light up when the cable is correctly connected.

Refer to the LED Indicator section for descriptions of each LED indicator. If a port LED is off, go

back and check for connectivity problems between that port and the network device connected.

3. Technical Specifications

Standards IEEE802.3/IEEE802.3u standards(10 base-T/100base-T)

Ports 5 ports with 4 PoE(PSE), supports auto-crossover &

auto-polarity

Transmission speed 100 Mbps(100base-T),10 Mbps(10base-T) Auto-negotiation

Switch technology store-and-forward

Protocols CSMA/CD