Specification

10 11
INSTALLATION INSTRUCTIONS
CAUTION: HOOD MAY HAVE VERY SHARP EDGES; PLEASE WEAR
PROTECTIVE GLOVES WHENEVER IT IS NECESSARY TO REMOVE ANY
PARTS FOR INSTALLING, CLEANING OR SERVICING.
Wall Mount Installation Method
1.
A. Find the 4 mounting holes in the back of the
range hood. Mark their locations at the installation
location with a pencil or marker.
B.
Drill 5/16 (8mm) hole at each of the marked
locations.
C.
Insert anchors along with screws into each drilled
hole. Firmly tighten the screw into place.
D.
Hang your Range Hood into place by aligning the
screws with the 4 mounting holes in the back of the
range hood. Lock into place by sliding down the
range hood.
RECIRCULATING CHARCOAL FILTERS
Skip this page if you are installing a Ducted Range Hood.
Charcoal Filters are only included with Ductless Models.
1.) Remove the aluminum filters.
2.) The charcoal filter is installed at the end of the motor.Align the
upper and lower holes , twist the carbon filter Counterclockwise
to lock into place.
3.) To replace the carbon filter, reverse the process and repeat.
NOTE: The carbon filter cannot be washed and reused and
must be replaced every 4-6 months, depending on use.