User's Manual

15
BACK PANEL
Bluetooth Sync
Depress this button in order to initiate pairing with your
Bluetooth enable device.
Bluetooth Indicator
This LED will illuminate blue to indicate that your Bluetooth
connection is established.
Bluetooth Boot
Depress this button to reset the pairing with your Bluetooth enabled device
without having to turn the speaker off.
EQ Presets
Use this button to toggle through the four different settings.
MAIN:
Setting for use as your main speaker facing towards your audience.
MONITOR:
Use this setting when your speaker is used as a monitor
facing towards you.
SUB:
This setting is used when your EON600 is used in conjuntion
with a separate SubWoofer.
SPEECH:
Best setting for giving speeches and spoken word.
Mic/Line Toggle
The MIC/LINE buttons selects between two sensitivity ranges. The buttons
are used to match the input sensitivity with the output level of the devices
connected to CH1 or CH2. Depressing the MIC/LINE switch selects
MIC (High Sensitivity).
CAUTION: Before adjusting this switch, be certain to rotate the control fully counter-clockwise. After
the MIC/LINE switch has been depressed, slowly rotate the control clock-wise until the desired
volume has been reached.
• Use the MIC position (depressed) when a microphone is connected.
• Use the LINE position (disengaged) when a line level source such as an audio mixing
console, audio playback device or electronic musical instrument is connected.
XLR-1/4” Combo Inputs
These balanced inputs accepts a standard XLR (female) connector and also a
1/4” TRS phone plug. A broad range of signals from microphones, audio mixing
consoles and electronic musical instruments may be connected here. The
sensitivity of these inputs are controlled by the MIC/LINE SWITCHES.
XLR Male Loop Thru
This XLR (male) output connector provides a method of sending audio
out to an external source. If signal is present on both inputs, the inputs will be
summed and sent out as a 50/50 mix
Power Switch
Enables the AC power to the unit on and off.
Power LED
This LED (White) lights to indicate that the speaker is plugged in and
switched ON.
Front LED On/Off
Toggles the LED (Blue) on front of speaker On or Off.
EQ+ Button
Once enabled via the app, the EQ+ toggles the applied EQ settings on/off.
CH1 & CH2 Signal Indicators
The SIGNAL LEDs (Green) illuminates to indicate a usable signal is
present at connected INPUTS.
Limit Indicator
The LIMIT LED (Red) illuminates to indicate that the system is approaching
limit. If this LED is on for more than the duration of brief dynamic peaks, the
system is being over-driven. Continuously over-driving the system will result in
unpleasant and fatiguing distortion and may lead to premature failure of your
speaker system.
Master Volume
Controls the master volume of the unit. By turning the knob counter-clockwise
you will be lowering the overall volume of the speaker. By turning the control
clockwise you will be increasing the overall volume of the speaker.
CH1 & CH2 Gain
Controls the gain of CH1 & CH2 respectively. By turning the signal counter-
clockwise you will be lowering the gain of your source material. By turning the
control clockwise you will be increasing the gain.