Specification

ManualsBrandsTypar ManualsAccessories9 in. x 75 ft. Flashing Flex Roll

THREE-PART SPECIFICATIONS

TYPAR

FLEXIBLE FLASHING

PART 1. GENERAL

1.1 Section Includes

A. Self-adhering Flashing (TYPAR

All-Temperature Flashing, TYPAR

Flexible Flashing, and TYPAR

Butyl Flashing)

B. Primers

C . Fasteners

1.2 References

A. ASTM International

1. ASTM D-3330, Standard test method for peel adhesion of pressure sensitive tape

2. ASTM D-5034, Standard practice for tensile strength of polymer or plastic sheet products

3. ASTM D-1970, Standard specification for water penetration around nails and cold temperature pliability

1.3 Submittals

A. Product Data: Submit current manufacturer technical literature for each type of product

B. Submit copies of test results showing performance characteristics equaling or exceeding those specified

1.4 Quality Assurance

A. Qualifications

1 . Installer shall have documented successful experience with installation of TYPAR

flashing products

2. Installation shall be in accordance with manufacturer’s installation guidelines and recommendations

PART 2. PRODUCTS

2.1 Manufacturer

A. Berry Plastics, 70 Old Hickory Blvd, Old Hickory, TN 37138; www.TYPAR.com

2.2 Materials

A. Self-adhering/straight flashing

1 . Description

i. Face material composition: woven polypropylene barrier

ii. Face color: gray

iii. Adhesive composition: butyl rubber adhesive

iv. Thickness: 15mil

v. Release liner: siliconized paper

vi. Dimensions: 4in. X 75ft.; 6in. X 75ft.; 9in. X 75ft.

B. Self-adhering flexible flashing

1 . Description

i. Face material composition: conformable textured cross-laminated polyolefin

ii. Face color: dark gray

iii. Adhesive composition: adhesive to copolymer

iv. Thickness: 50mil

v. Release liner: siliconized paper

vi. Dimensions: 6 in. X 75 ft.; 9 in. X 75 ft.

C. Performance characterizations

1 . Low temp Flex ASTM D-903 PASS

2. Nail sealability ASTM D-1970 PASS

3. Tensile strength ASTM D-5034 PASS

2.3 Accessories

A. Primer: Use 3M

™

S up er7 7

™

or equivalent

B. Seam tape: TYPAR

Construction Tape

C. Fastener: Fastener is dependent on substrate construction

D. Sealant: Must comply with ASTM C920 elastomeric polymer sealant

Summary of content (2 pages)

PAGE 1
TYPAR FLEXIBLE FLASHING ® THREE-PART SPECIFICATIONS PART 1. GENERAL 1.1 Section Includes A. Self-adhering Flashing (TYPAR® All-Temperature Flashing, TYPAR® Flexible Flashing, and TYPAR® Butyl Flashing) B. Primers C. Fasteners 1.2 References A. ASTM International 1. ASTM D-3330, Standard test method for peel adhesion of pressure sensitive tape 2. ASTM D-5034, Standard practice for tensile strength of polymer or plastic sheet products 3.
PAGE 2
TYPAR® FLEXIBLE FLASHING - THREE-PART SPECIFICATIONS PART 3. EXECUTION 3.1 Examination A. Verify substrate and surface conditions are in accordance with the flashing manufacturer’s recommendation. NOTE – Flashing manufacturer recommends weather barrier be installed prior to the installation of the windows. 3.2 Installation A. Follow the TYPAR® flashing installation procedures. 3.3 Protection A. Protect installed flashing from damage during construction. Made in U.S.A. of U.S. and Global Components.