Specification
PART 1 – GENERAL
1.1 Secon Includes
A. Self-adhering Flashing (TYPAR Flashing BA, TYPAR Flashing Flex and TYPAR Flashing RA).
B. Primers.
C. Fasteners.
1.2 References
A. ASTM Internaonal
1. ASTM D-903, Standard Test Method for Peel or Stripping Strength of adhesive bonds.
2. ASTM D –2533, Standard pracce for Twisng Load-Strain Properes.
3. ASTM D-1970, Standard Specicaon for Self-Adhesion polymer modied bituminous sheet
materials.
1.3 Submials:
A. Product Data: Submit manufacturer current technical literature for each type of product.
B. Submit copies of test results showing performance characteriscs equaling or exceeding those specied.
1.4 Quality Assurance
A. Qualicaons
1. Installer shall have documented successful experience with installaon of TYPAR Flashing products.
2. Installaon shall be in accordance with manufacturer’s installaon guidelines and recommendaons.
PART 2 - PRODUCTS
2.1 Manufacturer
A. Fiberweb, 70 Old Hickory Blvd, Old Hickory, TN 37138; 800-284-2780; www.TYPAR.com
2.2 Materials
A. Self-adhering/straight ashing
a. Descripon
i. Face material composion: smooth polypropylene barrier
ii. Face color: gray
iii. Adhesive composion: butyl adhesive
iv. Thickness: 15mil
v. Release liner: siliconized paper
vi. Dimensions: 4 in. X 75 . 6 in. X 75 . 9 in. X 75 .
B. Self-adhering ashing ex
a. Descripon
i. Face material composion: Conformable textured polyolen
ii. Face color: dark gray
iii. Adhesive composion: butyl adhesive
iv. Thickness: 60mil
v. Release liner: siliconized paper
vi. Dimensions: 6 in. X 75 . 9 in. X 75 .
C. Performance characterizaons
a. Low temp Flex ASTM D-903 PASS
b. Nail sealability ASTM D-1970 PASS
c. Tensile strength ASTM D-2523 PASS
2.3 Accessories
A. Primer: Use 3M™ Super77™ or equal
B. Seam tape: TYPAR construcon
C. Fastener: Fastener is dependent on substrate construcon
D. Sealant: Must comply with ASTM C920 elastomeric polymer sealant
PART 3 – EXECUTION
3.1 Examinaon
A. Verify substrate and surface condions are in accordance with the ashing manufacturer’s recommendaon.
NOTE – Flashing manufacturer recommends weather barrier be installed prior to the installaon of the windows.
3.2 Installaon
A. Follow the TYPAR ashing installaon procedures
3.3 Protecon
A. Protect installed ashing from damage during construcon
TYPAR® Flashing Flex Three Part Specs:
SPECIFICATIONS:
TYPAR® FLASHING FLEX
Three Part Specicaons
MADE IN USA. ICC #ESR-1404 • CCMC #12884-R • CCMC #12892-R
Please visit typar.com for installaon instrucons and warranty informaon
PGI, 70 Old Hickory Blvd., Old Hickory, TN 37138 USA, typar.com