User's Manual

in the interference-causing equipment standard entitled "Digital Apparatus," ICES-003 of Industry Canada.
Cet appareil numerique respecte les limites de bruits radioelectriques applicables aux appareils numeriques de
Classe B prescrites dans la norme sur le material brouilleur: "Appareils Numeriques," NMB-003 edictee par
l'Industrie.
ISED Canada: This device contains license-exempt transmitter (s)/receiver(s) that comply with Innovation, Science
and Economic Development Canada
’
s license-exempt RSS(s). Operation is subject to the following two conditions:
1. This device may not cause interference. 2. This device must accept any interference, including
interference that may cause undesired operation of the device.
L’
é
metteur/r
é
cepteur exempt de licence contenu dans le present appareil est conforme aux CNR d’Innovation,
Sciences et D
é
veloppement
é
conomique Canada applicables aux appareils radio exempts de licence. L’exploitation
est autoris
é
e aux deux conditions suivantes : 1. L’appareil ne doit pas produire de brouillage; 2.
L’appareil doit accepter tout brouillage radio
é
lectrique subi, m
ê
me si le brouillage est susceptible d’en
compromettre le fonctionnement.
The device meets the exemption from the routine evaluation limits in section 2.5 of RSS 102 and compliance with
RSS-102 RF exposure, users can obtain Canadian information on RF exposure and compliance.
Le dispositif rencontre l'exemption des limites courantes d'
é
valuation dans la section 2.5 de RSS 102 et la
conformit
é à
l'exposition de RSS-102 rf, utilisateurs peut obtenir l'information canadienne sur l'exposition et la
conformit
é
de rf.
This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. This
equipment should be installed and operated with a minimum distance of 20 centimeters between the radiator and
your body.
Cet
é
metteur ne doit pas
ê
tre Co-plac
é
ou ne fonctionnant en m
ê
me temps qu'aucune autre antenne ou
é
metteur.
Cet
é
quipement devrait
ê
tre install
é
et actionn
é
avec une distance minimum de 20
centim
è
tres entre le radiateur et votre corps.
End Product Labeling
The module is labeled with its own FCC ID and IC Certification Number. If the FCC ID and IC Certification Number
are not visible when the module is installed inside another device, then the outside of the device into which the
module is installed must also display a label referring to the enclosed module. In that case, the final end product
must be labeled in a visible area with the following: