Instructions

Table Of Contents

TD2200A - PROGRAMMING REPLACEMENT SENSOR

Original Sensor. White Label / Red Writing.

Original sensors are not programmable.

Replacement Learnable Sensor. White

Label / Green Writing.

ENTERING LEARN MODE

1) Hold the MUTE button until the settings menu is shown.

2) Press NEXT until ‘SET SENSOR ID’ is highlighted.

3) Press ENTER and the following screen will be displayed.

4) Insert the battery into your new ‘learnable sensor’ and the corresponding tyre

icon will flash, and the monitor will beep. If the monitor doesn’t beep try

removing and inserting the battery several times.

Only learnable sensors can be used for this function and they must be

433 MHz sensors designed to suit the TD-2200A.

5) Once the sensor is programmed, press the ESC button to exit learn mode.

PAGE 1
TD2200A - PROGRAMMING REPLACEMENT SENSOR Original Sensor. White Label / Red Writing. Original sensors are not programmable. Replacement Learnable Sensor. White Label / Green Writing. ENTERING LEARN MODE 1) Hold the MUTE button until the settings menu is shown. 2) Press NEXT until ‘SET SENSOR ID’ is highlighted. 3) Press ENTER and the following screen will be displayed. 4) Insert the battery into your new ‘learnable sensor’ and the corresponding tyre icon will flash, and the monitor will beep.