CONTENTS USING TIPS UNPACKING AND CHECKING EQUIPMENT Supplied Items. CHARGING BATTERY PACK Charging Preparation Charging Operation INSTALLATION OF ACCESSORIES Installation of Battery Pack Antenna Installation Installing Belt Clip -Installing Textual Micro/Speaker GETTING Familiar Radio Illustration LCD Display -Keypad Functions WORKING MODE -Frequency Mode {VFQ) Frequency-Channel Mode (MR) Channel Mode (CH) -FM Radii Mode (FM) 0.
USING TIPS Please read the following brief instructions, non-compliance with these rules may cause danger or violate the law. # Obey the local government regulation before using this radio, improper use may violate the law and be punished. # Turn off the radio before entering flammable or explosive areas. # Do not charge or change the battery in flammable or explosive areas. = Tum off the radio before getting close to the blasting zone or detonator areas.
CHARGING BATTERY PACK Charging Precaution The supplied battery pack of TH-UVF9 is a high-performance Li-ion battery with 7.4V standard voltage, 1500mAh high capacity in a very compact package. Under normal use, the battery pack may be used for approximately 500 charge cycles and more, after which operating time maybe expected to decreases. If you have an old battery pack which is displaying capacity which has become diminished, you should replace the pack with a new one.
Injury Tess conductive meats may Term a short droll and genitives mite heat Da deal with any battery careful, especially whom put it Info pocket, wallet or other metallic containers. Charging Operation ‘After Installing the battery pack, If the battery con shows CJ, it means that the battery pack is out of power, Please charge it.
Antenna Installation The supplied high gain antenna provides high performance at the entire VHF/UHF frequency range of the transceiver. To Install the supplied antenna, hold the bottom snd of the antenna, then screw it onto the ‘connector on the transceiver until it is snug. Do not over-tights by use of extreme force. Picture 3 To uninstall the antenna, hold the bottom end of it and tum it counterclockwise to remove it.
Installing External Micro/Speaker Open the cover of the Mic/speaker jack and insert the microprocessor plugs into the jack. Picture 7 Note: ws Using the external’ headset or Spermicide wil affect the wateriness performance of radio. ® If the lemma’ headset is not workable, peas use ihe heaths case.
RADIO ILLUSTRATION ANTENNA —POWER/VOLUME DIAL Connect the supplied This control toggle the antenna here transceiver's power banjo and adjust the audio volume level LL 7 Activates T-CALL (1750Hz) for | Indicator repeater access and transmit Toa) MDT and 2/5 tons signaling =) MIC/SP The more tare PTT == The jack provides connection Mc \coated here. Press It to transmit and release = points for microphone audio, The internal microphone.
LCD DISPLAY TT You will see various Icons shown on the screen when power on. The following table can < Squelch active help you identify icons’ meaning which display on LCD. 4 Beep tone active = Receive calling ID or MSG You'll Los vox + — Nudge 1 Scrambler active et 2 a 158 = Battery power indicator er CSS decoder active nes.
KEYPAD FUNCTIONS Enter menu | Switch the Upper menu |Lower menu | Switch VFO _— mode/confirm (Aor B tem, channel! (item, channel | mode and the setting frequency or frequency |or frequency (MR mode/exit to be the the setting “Operating” Band Pres sand presenter |No action Switch CH No action No action tum on the mode mode and radio VFO mods Press. Frequency/ frequency/ |Frequency/ |Frequency/ |Frequency/ key Channel No. | Channel No. | Channel No. [Channel No. | Shanna! No.
