User's Manual

P2P2

Channel Delete

1. Under channel mode, turn selector knob to select channel which you want to delete.

2. Press key and key together, current channel will be deleted and emitted

and emitted a prompt voice. Micon flashing means current channel is deleted.

Squelch Off

key programmed as Squelch Off to monitor the weak signal.

1. Squelch Off: Press key to disable squelch ,press key again to resume squelch.

Squelch level Setup

Setting the radio to a tight squelch level,you can avoid unwanted signals or noise,but

you may not receive a weak signal. Therefore,it will be better for you to select the normal squelch level.

1. While standby, press key and turn selector knob at the same time until

LCD appears and current squelch level

2. Turn selector knob or press MIC [ / ] key to set desired squelch level.

3. Press any key except and key to exit .

Frequency/Channel Scan

Frequency Scan

In frequency (VFO) mode, this function is designed to monitor signal of every communicative

frequency point of transceiver "step size" you have set.

Shortcut Operations

DOWN

Channel Scan

In channel mode, this function is designed to monitor signal in every channel.

1. In channel mode,Press key for 1s to enter into channel scan

2. Turn selector knob or press Microphone [ / ]

key to change scan direction.

3. Press any key except and key to exit.

CTCSS/DCS Encode and Decode Setup

Repeatedly press key to check whether set CTCSS/DCS encode and decode

in current channel or not.

1. When LCD appears iron, it means current channel with

CTCSS encode, turn selector knob or press Microphone's

[ / ] key to select desired CTCSS encode.

2. When LCD appears and iron, it means current channel

with CTCSS encode and decode, turn selector knob or press

Microphone's [ / ] to select desired CTCSS code.

3. When LCD appears DCS iron, it means current channe can

be set with DCS encode and decode together, turn selector

DOWN

1. In VFO mode,presst for 1s to enter into frequency scan.

2. Turn selector knob or press Microphone [ / ]

key tochange scan direction.

3. Press any key except and key to exit.